English
AV COMPU LINK Remote Control System
The AV COMPU LINK remote control system allows you to operate JVC’s video components (TV, VCR, and DVD player) through the receiver.
To use this remote control system, you need to connect the video components you want to operate following the diagrams and the procedure below.
7AV COMPU LINK connection
Rear panel
VCR
VHS |
AV
COMPU LINK
DVD player
RIGHT
DVD |
AV
COMPU LINK
AV |
COMPU LINK |
TV
AV
COMPU LINK EX
AV
COMPU LINK III
Note:
You can connect to the TV with the AV COMPU LINK EX or AV COMPU LINK III terminal.
A TV with AV COMPU LINK RECEIVER/AMP terminal can not be used.
7Video cable connection
Connect the DVD player and/or the VCR to this receiver using the VIDEO (composite video) terminals, and connect this receiver to the TV’s Video Input 2 terminals (composite video input) using composite video cables.
Notes:
•When connecting only the VCR or DVD player to this receiver, connect it directly to the receiver using cables with the monaural
•Make sure that the remote control code of the VCR connected to the VCR jacks is set to code “A.”
•Refer also to the manuals supplied with your video components.
7Connecting procedure
1If you have already plugged your VCR, DVD player, TV and this receiver into the AC outlets, unplug their AC power cords first.
2Connect your VCR, DVD player, TV and this receiver as illustrated above, using the cables with monaural
3Connect the audio/video input/output jacks on VCR, DVD player, TV and this receiver (see page 8).
4Plug the AC power cords of the components into the AC outlets.
5When turning on the TV for the first time after the AV COMPU LINK connection, turn the TV volume to the minimum using the TV volume control on the TV.
6Turn on the other connected components first, then turn on this receiver.
•When turning on the VCR, use the remote control supplied with this receiver (press STANDBY/ON 
VCR).
27
