Getting Started
English
Digital Connections
This receiver is equipped with two DIGITAL IN
You can connect any component to one of the digital terminals using a digital coaxial cable (not supplied) or digital optical cable (not supplied).
Digital coaxial cable
Digital optical cable
IMPORTANT:
•When connecting a video component using the digital terminal, you also need to connect it to the video jack on the rear. Without connecting it to the video jack, you cannot view the playback picture.
•After connecting the components using the DIGITAL IN terminals, correctly set the following if necessary:
–Set the digital input (DIGITAL IN) terminal setting correctly. For details, see “Selecting the Digital Input
–Select the digital input mode correctly. For details, see “Selecting the Analog or Digital Input Mode” on page 15.
Connecting the Power Cord
Before plugging the power cord into an AC outlet, make sure that all connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference. We recommend that you use a coaxial cable to connect the antenna, since it is
CAUTIONS:
•Do not plug in before setting the voltage selector switch on the rear of the unit and all connection procedures are complete.
•Do not touch the power cord with wet hands.
•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.
Putting Batteries in the Remote Control
Rear panel
Before using the remote control, put two supplied batteries first.
•When using the remote control, aim the remote control directly at the remote sensor on the front panel.
1 On the back of the remote control, remove the battery cover.
2 Insert batteries.
When the component has a digital coaxial output terminal, connect it to the DIGITAL 1 (DVD) terminal, using the digital coaxial cable (not supplied).
When the component has a digital optical output terminal, connect it to the DIGITAL 2 (CD) terminal, using the digital optical cable (not supplied).
Before connecting a digital optical cable, unplug the protective plug.
Notes:
DIGITAL 1 (DVD)
DIGITAL 2 ( CD )
DIGITAL IN
• Make sure to match the polarity:
(+) to (+) and
3 Replace the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity: |
(+) to (+) and |
• Use the correct type of batteries. Batteries that look similar may |
differ in voltage. |
• Always replace both batteries at the same time. |
•When shipped from the factory, the DIGITAL IN terminals have been set for use with the following components:
–DIGITAL 1 (coaxial): For DVD player
–DIGITAL 2 (optical): For CD player
•When you want to operate the CD player or CD recorder using the COMPU LINK remote control system, connect the target component also as described in “Analog Connections” (see page 7).
•When you want to operate the DVD player using the AV COMPU LINK remote control system, connect the DVD player also as described in “Analog connections” (see page 8).
• Do not expose batteries to heat or flame. |
9
