Siemens S223, S323 user manual Interface Configuration Mode, Rmon Configuration Mode

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

3.1.8Interface Configuration Mode

To open Interface Configuration mode, enter the command, interface INTERFACE, on Global Configuration mode, and then the prompt is changed from SWITCH(config)# to SWITCH(config-if)#.

Command	Mode	Description
interface INTERFACE	Global	Opens Interface Configuration mode.

Interface Configuration mode is to assign IP address in Ethernet interface and to activate or deactivate interface.

Tab. 3.8 shows a couple of main commands of Interface Configuration mode.

Command	Description
bandwidth	Configures bandwidth used to make routing information.
description	Makes description of interface.
ip	Assigns IP address.
shutdown	Deactivates interface.
mtu	Sets MTU value to interface.

Tab. 3.8 Main Commands of Interface Configuration Mode

3.1.9RMON Configuration Mode

To open RMON-Alarm Configuration mode, enter rmon-alarm<1-65534>. To open RMON-Event Configuration mode, input rmon-event<1-65534>. And to open RMON- History Configuration mode, enter rmon-history<1-65534>.

Tab. 3.9 shows a couple of important main commands of RMON Configuration mode.

Command	Description
active	Enables each RMON configuration.
community	Configures password for trap message transmission right.
description	Describes the RMON event.
falling-event	Configures to generate RMON alarm when object is less than config-
	ured threshold.
falling-threshold	Defines the falling threshold
owner	Shows the subject, which configures each RMON and uses related
	information.
rising-event	Configures to generate RMON alarm when object is more than config-
	ured threshold.
requested-buckets	Defines a bucket count for the interval.

Tab. 3.9 Main Commands of RMON Configuration Mode

A50010-Y3-C150-2-7619 33