Siemens S323, S223 user manual Rate Limit, Vrrp Statistics, Configuration mode

UMN:CLI			User Manual
			SURPASS hiD 6615 S223/S323 R1.5
	Also, to make Preempt “enable” as default setting, use the following command on VRRP
	configuration mode.
	Command	Mode	Description
	no preempt	VRRP	Deletes the former configuration of Preempt to enable
			it.

8.4.1.7VRRP Statistics

To display the VRRP statistics that packets have been sent and received, use the follow- ing command.

Command	Mode	Description
	Enable
show vrrp stat	Global	Shows statistics of packets in Virtual Router Group.
	Bridge
	VRRP

The following is an example of viewing statistics of packets in Virtual Router Group.

SWITCH(config)# show vrrp stat
VRRP statistics :
VRRP packets rcvd with invalid TTL	0
VRRP packets rcvd with invalid version	0
VRRP packets rcvd with invalid VRID	0
VRRP packets rcvd with invalid size	0
VRRP packets rcvd with invalid checksum	0
VRRP packets rcvd with invalid auth-type	0
VRRP packets rcvd with interval mismatch	0

SWITCH(config)#

To clear the VRRP statistics information, use the following command.

Command	Mode	Description
	Enable
clear vrrp stat	Global	Clears statistics of packets in Virtual Router Group.
	Bridge
	VRRP

8.5Rate Limit

User can customize port bandwidth according to user’s environment. By this configuration, you can prevent a certain port to monopolize whole bandwidth so that all ports can use bandwidth equally. Egress and ingress can be configured both to be same and to be dif- ferent.

The hiD 6615 S223/S323 can apply the rate limit and support ingress policing and egress shaping.

234 A50010-Y3-C150-2-7619