Siemens S323 SPT Switchover, Reachability for PIM Register Process, 312 A50010-Y3-C150-2-7619

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

sage in response. It is normally the loopback interface address, but can also be other physical addresses. This address must be advertised by unicast routing protocols on the DR.

Command	Mode	Description
ip pim register-source {A.B.C.D		Configures the source address of register message.
		A.B.C.D: IP address to be used as source
INTERFACE}	Global
		INTERFACE: interface address to be used as source
no ip pim register-source		Disables the registration suppression time.

By default, the IP address of the outgoing interface of the DR leading to the RP is used as the IP source address of a register message.

9.3.5.5Reachability for PIM Register Process

To enable the RP reachability verification for PIM Register processing at the DR, use the following command.

Command	Mode	Description
ip pim register-rp-reachability		Enables the RP reachability verification function.
	Global
no ip pim register-rp-reach-		Disables the RP reachability verification function.
ability		(default)

i

This command is disabled by default.

9.3.6SPT Switchover

This command is used to enable and configure the bandwidth of the switchover from RPT to SPT for the certain group. If a source sends at a rate greater than or equal to traffic rate (the kbps value), a PIM join message is triggered toward the source to construct a source tree. Specifying a group list access list indicates the groups to which the threshold applies. If the traffic rate from the source drops below the threshold traffic rate, the leaf router will switch back to the shared tree and send a prune message toward the source.

Command	Mode	Description
ip pim spt-threshold		Enables the ability for the last-hop PIM router to switch
		to SPT.
ip pim spt-threshold group-list		Enables the ability for the last-hop PIM router to switch
{<1-99> <1300-1999> AC-		to SPT for multicast group addresses specified by the
CESS-LIST}	Global	given access list.
no ip pim spt-threshold
no ip pim spt-threshold group-		Disables switching to SPT option.
list {<1-99> <1300-1999> AC-
CESS-LIST}

312 A50010-Y3-C150-2-7619