Siemens S223, S323 Port Description, Following is an example of configuring flow control to port

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

To configure flow control of the Ethernet port, use the following command.

Command	Mode	Description
port flow-control PORTS {on	Bridge	Configures flow control for a specified port, enter the
off}		port number. (default: off)

The following is an example of configuring flow control to port 25.

SWITCH(bridge)# show port 25

------------------------------------------------------------------------

NO TYPE PVID STATUS MODE FLOWCTRL INSTALLED (ADMIN/OPER)

------------------------------------------------------------------------

25 Ethernet 1 Up/Down Auto/Half/0

SWITCH(bridge)# port flow-control 25 on

SWITCH(bridge)# show port 25

Off

Y

-------------------------------------------------------------------

NO	TYPE	PVID	STATUS	MODE	FLOWCTRL INSTALLED
		(ADMIN/OPER)

-------------------------------------------------------------------
25: Ethernet	1	Up/Down Auto/Half/0	On	Y
SWITCH(bridge)#

5.2.6Port Description

To specify a description of an Ethernet port, use the following command.

Command	Mode	Description
port description PORTS		Specifies a description of an Ethernet port.
DESCRIPTION	Bridge
no port description PORTS		Deletes description of specified port.

To view description of port, use the following command.

Command	Mode	Description
	Enable
show port description PORTS	Global	Shows description of one port or more.
	Bridge
	Interface

The following is an example of making description of port 1 and viewing it.

SWITCH(bridge)# port description 1 test1

SWITCH(bridge)# show port description 1

------------------------------------------------------------

NO TYPE	STATE	LINK	DESCRIPTION
	(ADM/OPR)

------------------------------------------------------------

1 Unknown	Up/Down	0HDX test1
SWITCH(bridge)#

A50010-Y3-C150-2-7619 77