Siemens S223 Host Route, Passive Interface, To make it as a default, use the following command

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

The following example shows how to configure the distance with more than 2 options:

•distance ospf external <1-255>inter-area <1-255>

•distance ospf inter-area <1-255>intra-area <1-255>

To make it as a default, use the following command.

Command	Mode	Description
no distance ospf	Router	Restores it as the default.

10.2.14Host Route

OSPF regards routing information of specific host as stub link information. Routing infor- mation can be assigned to each host which is connected with one router.

To configure the routing information to each host, use the following command.

Command	Mode	Description
host A.B.C.D area A.B.C.D	Router	Configures the routing information to
		each host.
host A.B.C.D area A.B.C.D cost <0-65535>

Command	Mode	Description
host A.B.C.D area <1-4294967295>		Configures the routing information to
	Router
host A.B.C.D area <1-4294967295> cost <0-
		each host.
65535>

10.2.15Passive Interface

The passive interface which is configured by OSPF network operate as stub area. There- fore passive interface can not exchange the OSPF routing information.

To configure the passive interface, use the following command.

Command	Mode	Description
passive-interface INTERFACE	Router	Configures the passive interface.
[A.B.C.D]

To release the configured as passive interface, use the following command.

Command	Mode	Description
no passive-interface INTERFACE	Router	Releases the configured as passive interface.
[A.B.C.D]

A50010-Y3-C150-2-7619 355