Siemens S223, S323 Configuring Rate Limit, To set a port bandwidth, use the following command

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

8.5.1Configuring Rate Limit

To set a port bandwidth, use the following command.

Command		Mode	Description
rate PORTS RATE [egress	in-		Sets port bandwidth. If you input egress or ingress, you
			can configure outgoing packet or incoming packet. The
gress]
			unit is 64 Kbps.
		Bridge
no rate PORTS			Clears rate configuration of a specific port.
no rate PORTS [egress ingress]			Clears rate configuration of a specific port by transmit-
			ting direction.

Unless you input neither egress nor ingress, they are configured to be same. To switch, egress is incoming packet. To display the configured bandwidth, use the following com- mand.

Command	Mode	Description
show rate	Global	Shows the configured bandwidth.

8.5.2Sample Configuration

The following is an example of showing the configuration after setting the bandwidth of 64Mbps to port number 1 and 128Mbps to the port number 2.

SWTICH(bridge)# rate 1 64 SWTICH(bridge)# rate 2 128 SWTICH(bridge)# show rate unit : kbps E : Enhanced

------------------------------------------------------------------------------

Port	Ingress	Egress	Port		Ingress	Egress
------------------------------------------					+-----------------------------------
1	64	64		2	128	128
3	N/A	N/A		4	N/A	N/A
5	N/A	N/A		6	N/A	N/A
7	N/A	N/A		8	N/A	N/A

SWTICH(bridge)#

A50010-Y3-C150-2-7619 235