Siemens S223, S323 Creating Igmp Profile, Policy of Igmp Profile, Group Range of Igmp Profile

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

dropped, and the port is not allowed to receive IP multicast traffic from that group. If the filtering action permits access to the multicast group, the IGMP report from the port is forwarded for normal processing.

IGMP filtering controls only group specific query and membership reports, including join and leave reports. It does not control general IGMP queries. IGMP filtering has no rela- tionship with the function that directs the forwarding of IP multicast traffic.

9.2.8.1Creating IGMP Profile

You can create or modify the IGMP profile to be used for filtering IGMP join requests from a port. The system prompt will be changed to SWITCH(config-igmp-profile[N])# from SWITCH(config)#.

Command	Mode	Description
ip igmp profile <1-2147483647>	Global	Configures IGMP profile.

To delete the created IGMP profile, use the no ip igmp profile <1-2147483647> com- mand on global mode.

To display the IGMP profile, use the following command.

Command	Mode	Description
	Enable
show ip igmp profile [<1-2147483647>]	Global	Shows IGMP profile.
	Bridge

9.2.8.2Policy of IGMP Profile

Configure the action to permit or deny access to the IP multicast address using the follow- ing command.

Command	Mode	Description
{permit deny}	IGMP	Configures the action of IGMP profile.
	Profile

9.2.8.3Group Range of IGMP Profile

Configure the group range of IGMP Profile using the following command.

Command	Mode	Description
		Configures a group range.
range A.B.C.D [A.B.C.D]	IGMP	A.B.C.D: low IP multicast address
	Profile	A.B.C.D: high IP multicast address
no range A.B.C.D [A.B.C.D]		Deletes a configured group range.

A50010-Y3-C150-2-7619 301