Siemens S223, S323 user manual Protocol-Based Vlan, MAC address-based Vlan, Displaying Vlan

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

8.1.1.5Displaying VLAN

To display a configuration of VLAN, use the following command.

Command	Mode	Description
	Enable	Shows the configuration for specific VLAN, enter VLAN
show vlan [VLANS]	Global
		ID.
	Bridge

8.1.2Protocol-Based VLAN

User can use a VLAN mapping that associates a set of processes within stations to a VLAN rather than the stations themselves. Consider a network comprising devices sup- porting multiple protocol suites. Each device may have an IP protocol stack, an AppleTalk protocol stack, an IPX protocol stack and so on.

If we configure VLAN-aware switches such that they can associate a frame with a VLAN based on a combination of the station’s MAC source address and the protocol stack in use, we can create separate VLANs for each set of protocol-specific applications.

To configure protocol-based VLAN, follow these steps.

1.Configure VLAN groups for the protocols you want to use.

2.Create a protocol group for each of the protocols you want to assign to a VLAN.

3.Then map the protocol for each interface to the appropriate VLAN

Command	Mode	Description
		Configures protocol based VLAN.
vlan pvid PORTS [ethertype		PORTS: input a port number
ETHERTYPE] <1-4094>	Bridge	ETHERTYPE: 0x800
		1-4094: Vlan ID
no vlan pvid PORTS ethertype		Removes protocol based VLAN.
[ETHERTYPE]

Because Protocol Based VLAN and normal VLAN run at the same time, Protocol Based VLAN operates only matched situation comparing below two cases.

1.When Untagged Frame comes in and matches with Protocol VLAN Table, tags PVID which configured on Protocol VLAN. But in no matched situation, tags PVID which configured on and operates VLAN.

2.When Tagged Frame comes in and VID is 0, it switches by Protocol VLAN Table. But if VID is not 0, it switches by normal VLAN Table.

8.1.3MAC address-based VLAN

In order to configure VLAN based on MAC address, user should designate MAC address. use the following command.

A50010-Y3-C150-2-7619 181