Siemens S323 Port Security on Port, To configure max new hosts, use the following command

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

To configure max new hosts, use the following command.

Command	Mode	Description
max-new-hosts PORTS MAX-		The number of MAC address that can be learned on
MAC-NUMBER	Bridge	the port for a second.
max-new-hosts system PORTS		The number of MAC address that can be learned on
MAX-MAC-NUMBER		the system for a second.

To delete configured max new hosts, use the following command.

Command	Mode		Description
no max-new-hosts PORTS		Deletes the number	of	MAC	address	that	can	be
		learned on the port.
	Bridge
no max-new-hosts system		Deletes the number	of	MAC	address	that	can	be
		learned on the system.

To display configured max new hosts, use the following command.

Command	Mode	Description
	Enable
show max-new-hosts	Global	Shows the configured Max-new-hosts.
	Bridge

If MAC that already counted disappears before passing 1 second and starts learning again, it is not counted. In case the same MAC is detected on the other port also, it is not counted again. For example, if MAC that was learned on port 1 is detected on port 2, it is supposed that MAC moved to the port 2. So, it is deleted from the port 1 and learned on the port 2 but it is not counted.

7.10Port Security

You can use the port security feature to restrict input to an interface by limiting and identi- fying MAC addresses of the PCs that are allowed to access the port. When you assign secure MAC addresses to a secure port, the port does not forward packets with source addresses outside the group of defined addresses. If you limit the number of secure MAC addresses to one and assign a single secure MAC address, the PC attached to that port is assured the full bandwidth of the port.

7.10.1Port Security on Port

Step 1

Enable port security on the port.

Command	Mode	Description
port security PORTS	Bridge	Enables port security on the port.
		PORT: selects port number

158 A50010-Y3-C150-2-7619