Siemens S323 Displaying Configuration, To delete the edge port mode, use the following command

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

To delete the edge port mode, use the following command.

Command	Mode	Description
no stp edge-port PORTS	Bridge	Deletes port edge mode:
		PORTS: select the port number.

8.3.5.9Displaying Configuration

To display the configuration after configuring STP, RSTP, and MSTP, use the following command.

Command	Mode	Description
show stp		Shows the configuration of STP/RSTP/MSTP.
show stp mst		Shows the configuration when it is configured as
		MSTP.
show stp mst MSTID-RANGE		Shows the configuration of specific Instance, enter the
	Enable	instance number.
	Global
		Shows the configuration of the specific Instance for the
	Bridge
		ports:
show stp mst MSTID-RANGE{all		MSTID_RANGE: select the MST instance number.
PORTS} [detail]		all: select all ports.
		PORTS: select port number.
		detail: show detail information (as option).

i

i

i

In case STP or RSTP is configured in the SURPASS hiD 6615 S223/S323, you should configure MSTID-RANGEas 0.

To display a configured MSTP of the switch, use the following command.

Command	Mode	Description
	Enable	Shows the MSTP configuration identifier:
show stp mst config-id {current		current: shows the current configuration as it is used to
	Global
pending}		run MST.
	Bridge
		pending: shows the edited configuration.

For example, after the user configures configuration ID, if you apply it to the switch with stp mst config-id commit command, you can check configuration ID with the show stp mst config-id current command.

However, if the user did not use the stp mst config-id commit command in order to ap- ply to the switch after configuration, the configuration could be checked with the show stp mst config-id pending command.

216 A50010-Y3-C150-2-7619