UMN:CLI

User Manual

 

SURPASS hiD 6615 S223/S323 R1.5

 

 

 

8.3.5.5MST Region

If MSTP is established in the hiD 6615 S223/S323, decide which MST region the switch is going to belong to by configuring MST configuration ID. Configuration ID contains region name, revision, VLAN map.

To set configuration ID, use the following command.

Command

 

Mode

Description

 

 

 

 

 

 

 

Designate the name for the region:

stp mst config-id name NAME

 

name: set the MST region name.

 

 

 

NAME: enter name to give the MST region.

 

 

 

 

 

 

 

Configure the range of VLAN that is going to be group-

stp mst config-id map <1-64>

 

ing as a region:

Bridge

1-64: select an instance ID number.

VLAN-RANGE

 

 

 

VLAN-RANGE: enter a number of the VLANs to be

 

 

 

 

 

 

mapped to the specified instance.

 

 

 

 

stp mst config-id revision

<0-

 

Configure the switches in the same MST boundary as

 

same number:

65535>

 

 

 

 

0-65535: set the MST configuration revision number.

 

 

 

 

 

 

 

i

In case of configuring STP and RSTP, you don’t need to configure configuration ID. If it is configured, error message is displayed.

To delete configuration ID, use the following command.

Command

Mode

Description

 

 

 

no stp mst config-id

 

Delete the entire configured configuration ID.

 

 

 

no stp mst config-id name

 

Deletes the name of region, enter the MST region

 

name.

 

 

 

Bridge

 

no stp mst config-id map <1-64>

Deletes entire VLAN-map or part of it, select the in-

 

stance ID number and the number of the VLANs to

[VLAN-RANGE]

 

 

remove from the specified instance.

 

 

 

 

 

no stp mst config-id revision

 

Deletes the configured revision number.

 

 

 

After configuring configuration ID in the hiD 6615 S223/S323, you should apply the con- figuration to the switch. After changing or deleting the configuration, you must apply it to the switch. If not, it does not being injected into the switch.

To apply the configuration to the switch after configuring configuration ID, use the follow- ing command.

Command

Mode

Description

 

 

 

stp mst config-id commit

Bridge

Commits the configuration of the region.

 

 

 

i

After deleting the configured configuration ID, apply it to the switch using the above com- mand.

214

A50010-Y3-C150-2-7619

Page 214
Image 214
Siemens S323, S223 user manual MST Region