Siemens S223, S323 user manual Sample Configuration 4 Configuring QinQ, Switch

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

i

---------------------------------------------------------------

1 2 3 4

Ethertype VID 123456789012345678901234567890123456789012

---------------------------------------------------------------

0x0800	5	.p
0x0900	6	...p

SWITCH(bridge)#

With above configuration, the packets from port number 2 and 4 are decided according to the protocol. In case the protocol is incongruous, the route is decided according to the port based VLAN.

[Sample Configuration 4] Configuring QinQ

10 port of SWITCH 1 and 11 port of SWITCH 2 are connected to the network where dif- ferent VLANs are configured. To communicate without changing VLAN configuration of SWITCH 1 and SWITCH 2 which communicate with PVID 10, configure it as follows.

You should configure the ports connected to network communicating with PVID 11 as Tagged VLAN port.

< SWITCH 1 >

SWITCH(bridge)# vlan dot1q-tunnel enable 10

SWITCH(bridge)# vlan pvid 10 11

SWITCH(bridge)# show vlan dot1q-tunnel

Tag Protocol Id : 0x8100 (d: double-tagging port)

----------------------------------------------------

		1	2	3	4
Port	123456789012345678901234567890123456789012
----------------------------------------------------
dtag		.........	d

SWITCH(bridge)#

< SWITCH 2 >

SWITCH(bridge)# vlan dot1q-tunnel enable 11

SWITCH(bridge)# vlan pvid 11 11

SWITCH(bridge)# show vlan dot1q-tunnel

Tag Protocol Id : 0x8100 (d: double-tagging port)

----------------------------------------------------

		1	2	3	4
Port	123456789012345678901234567890123456789012
----------------------------------------------------
dtag		..........	d

SWITCH(bridge)#

[Sample Configuration 5] Configuring Shared VLAN with FID

Configure br2, br3, br4 in the hiD 6615 S223/S323 configured Layer 2 environment and 24 ports as Uplink port is configured. To transmit untagged packet through Uplink port rightly, follow below configuration.

A50010-Y3-C150-2-7619 191