Siemens S223, S323 user manual Identifying Member Ports within Lacp, Bpdu Transmission Rate

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

8.2.2.4Identifying Member Ports within LACP

The port configured as member port is basically configured to aggregate to LACP. How- ever, even though the configuration as member port is not released, they could operate as independent port without being aggregated to LACP. These independent ports cannot be configured as trunk port because they are independent from being aggregated to LACP under the condition of being configured as member port.

To configure member port to aggregate to LACP, use the following command.

Command		Mode	Description
lacp port aggregation	PORTS		Designates whether a member port joins LACP or not,
		Bridge	select the member port should be included. (default:
{aggregatable individual}
			aggregatable)

To clear aggregated to LACP of configured member port, use the following command.

Command	Mode	Description
no lacp port aggregation PORTS	Bridge	Deletes the configured member port in LACP, select
		the member port.

8.2.2.5BPDU Transmission Rate

Member port transmits BPDU with its information. For the hiD 6615 S223/S323, it is pos- sible to configure the BPDU transmission rate, use the following command.

Command	Mode	Description
		Configures BPDU transmission rate:
lacp port timeout PORTS {short	Bridge	PORTS: select the port number.
long}		short: fast rate (once every 1 sec)
		long: slow rate (30 sec: default)

To clear BPDU transmission rate, use the following command (clear means long timeout).

Command	Mode	Description
no lacp port timeout PORTS	Bridge	Deletes BPDU transmission rate of configured member
		port, select the port number.

8.2.2.6Key value of Member Port

Member port of LACP has key value. All member ports in one aggregator have same key values. To make an aggregator consisted of specified member ports, configure different key value with key value of another port.

Command	Mode	Description
lacp port admin-key PORTS <1-		Configures key value of member port:
	Bridge	PORTS: select the port number.
15>
		1-15: select the port key value. (default: 1)

A50010-Y3-C150-2-7619 197