2.1 ExpressNAV provides web-based interface
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters based on a specific topic.
ATTO ExpressNAV is the recommended management tool for the iPBridge. It is a web- based graphical user interface (GUI) that allows you to manage the iPBridge by clicking choices and commands in traditional GUI fashion or by entering CLI commands directly, as you would in a terminal emulation session.
Before opening an ExpressNAV session, you must install the ExpressNAV interface. Refer to Configuring the iPBridge on page 13.
To open an ExpressNAV session
1Point your browser at the IP address of the iPBridge. Refer to Configuring the iPBridge on page 13.
2The ExpressNAV home page is displayed. Click Enter.
3Enter the username and password values.
Note
The default values are username: “root” and
password: “Password”. The username is case insensitive and password is case sensitive.
The Status page appears.
Each page can be reached through the menu at the side of each page An image on each page’s header shows each port in the product faceplate. Each port is clickable and will also take you to the appropriate page.
Status
Displays iPBridge information
•Vendor ID
•Product ID
•Firmware revision number
•Serial number
•Ethernet port IP addresses
•Ethernet port status
Serial Port Configuration
Configure the baud rate and echo parameters. See Serial port configuration commands on page 33 for details on each option.
Ethernet Port Configuration Configures each port independently for the following parameters
•Enable/disable DHCP
•IP address
•IP gateway
•IP subnet mask
•Ethernet speed
•MTU
Note
Ethernet speed settings in the host must be the same as Ethernet speed settings in the iPBridge. The iPBridge default Ethernet speed is auto: your host must be set to auto. If you set Ethernet speed to 10, your host must be set to Ethernet speed 10, half duplex. If you set Ethernet speed to 100, your host must be set to Ethernet speed 100, half duplex.
See Ethernet commands on page 35 for details on each parameter.
SCSI Configuration
Displays include a list of attached devices for the SCSI bus. Configurable options are
•Port Bus Speed
•Synchronous Transfer
•Wide Transfer
•Initiator ID
•Bus Reset on Startup
•Bus Termination
•SCSI Port Reset
See SCSI configuration commands on page 31 for details on each parameter.
19
ATTO Technology Inc. iPBridge Installation and Operation Manual
