Ethernet commands | ATTO Technology 1550D/E, 1500D/E guide

2.2.7 Ethernet commands

These commands configure the management and data Ethernet ports including Telnet parameters.

DPMTU

Controls the MTU (Maximum Transmission Unit) used by the data port: increasing the MTU may improve throughput on the ipBridge data ports. The MTU for the management port cannot be changed.

Default: 1514

Set syntax: set DPMTU dp0 [1514 9014]

Requires a SaveConfiguration command

Get syntax: get dp0 DPMTU

Get syntax: get IPAddress dp0

IPDHCP

Selecting DHCP allows the iPBridge to request an IP address from the network DHCP server. The network must have at least one DHCP server

Default: enabled

Set syntax: set IPDHCP dp0 [enabled disabled] Requires a SaveConfiguration command

Get syntax: get IPDHCP dp0

EthernetSpeed

Specifies the speed of the Ethernet ports. If auto is enabled, the speed will be negotiated.10 and 100 speeds are half duplex Ethernet speed settings in the host must be the same as Ethernet speed settings in the iPBridge. The iPBridge default Ethernet speed is auto: your host must be set to auto. If you set Ethernet speed to 10, your host must be set to Ethernet speed 10, half duplex. If you set Ethernet speed to 100, your host must be set to Ethernet speed 100, half duplex.

Choices are

10 = 10 baseT

100 = 100 baseT

1000 =1000baseT Default: auto

Set syntax: set EthernetSpeed dp0 [10 100 1000 Auto] Requires a SaveConfiguration command

Get syntax: get EthernetSpeed dp0

IPGateway

Controls the current gateway. If IPDHCP is enabled (see above), get command reports the current IP gateway assigned by the network DHCP server

Default: 0.0.0.0

Set syntax: set IPGateway dp0 xxx.xxx.xxx.xxx Requires a SaveConfiguration command

Get syntax: get dp0 IPGateway

IPSubnetMask

Controls the current subnet mask. If IPDHCP is enabled (see above), get command reports the current subnet mask assigned by the DHCP server

Default: 255.255.0.0

Set syntax: set IPSubnetMask dp0 xxx.xxx.xxx.xxx Requires a SaveConfiguration command

Get syntax: get dp0 IPSubnetMask

Exit

Exits the current Telnet CLI session; it has no effect if used during a serial CLI session.

Immediate command: Exit

IPAddress

Controls the IP address of the iPBridge Ethernet data ports. If IPDHCP is enabled, the get command reports the current IP address assigned by the network DHCP server, followed by the DHCP identifier.

Default IP address: 10.0.0.1

Set syntax: set IPAddress dp0 xxx.xxx.xxx.xxx Requires a SaveConfiguration command

Password

Specifies a password for all sessions: Telnet, FTP and ExpressNAV web-based interface. You will be prompted for the current password, to enter the new password, and to confirm the new password. Passwords are case sensitive, 0-32 characters with no spaces.An empty password can be configured by entering the Password confirmation prompts with no parameters. The command RestoreConfiguration default sets the password to its default value.

Default: Password

Set syntax: set Password