European Standards | ATTO Technology 1500D/E, 1550D/E guide

European Standards

Declaration of Conformity

This following statement applies to the ATTO iPBridge.

This device has been tested in the basic operating configuration and found to be compliant with the following European Union standards

Application of Council Directive: 89/336/EEC

Standard(s) to which conformity is declared: EN55022, EN50082-1

This Declaration will only be valid when this product is used in conjunction with other CE approved devices and when the entire system is tested to the applicable CE standards and found to be compliant.

ii Appendix

Image 59

ATTO Technology 1500D/E, 1550D/E operation manual European Standards

Contents

IPBridgeTM 1500D/E IPBridgeTM 1550D/E Page Page Contents Connecting Scsi devices to the Scsi port Serial port configuration commands Mapping commands Term Definition GlossaryIntelligent Bridging Architecture, the engine Introduction IPBridge 1550 features Setting up the iPBridgeIPBridge1500 features Scsi Possible SAN/NAS Configuration Atto iPBridge 1500E Pin outs of the RJ11 connector, part number CBL-0911-001 Exhibit 1.1-1 iPBridge 1500E board layout Installation instructions Atto iPBridge 1500D Exhibit 1.2-1 iPBridge 1500D back panel Atto iPBridge 1550E Exhibit 1.3-1 iPBridge 1550E board layout Atto iPBridge 1550D Exhibit 1.4-1 iPBridge 1550D back panel To set Scsi port bus speed and transfer rates Connecting Scsi devices to the Scsi portTo connect Scsi devices to the Atto iPBridge Examples CablingCable types To find the iPBridge Configuring the iPBridgeConnecting using the GbE port Select Internet Options Using Atto ExpressNAVConnecting using the serial port To optimize ExpressNAV in Internet Explorer Enter Using TelnetTo connect using Telnet Installation Configuration Managing the iPBridge Change default username, passwordScsi configuration To change the default administrator password Mapping Ethernet port configurationISCSI configuration OEM configuration services To open an ExpressNAV session Serial Port ConfigurationExpressNAV provides web-based interface Status Restart Firmware Bridge ConfigurationAdvanced CLI Configuration To use the Advanced Configuration CLI provides ASCII-based interface Get Set Command Parameter 1 ParameterCommand conventions Configuration & Management CLI Command Defaults Example CLI commands summary OEM configuration file Defaults Limits General use commands VerboseMode From information commands. Choices are enabled or disabled Diagnostic commands SCSITargets CLI Error MessagesRouteDisplay SCSIPortList Maintenance commands Configuration CLI Scsi configuration commands SpeedWrite SerialPortEcho Serial port configuration commandsSerialPortBaudRate Configuration CLI Ethernet commands ReadOnlyUsername ReadOnlyPassword ISCSI commands MultiTargetMode ISNSServer Route Mapping commandsAutoMap Configuration CLI Privileged OEM configuration services VendorID OEM Config file supported commandsModelNumber ProductID Node names Single target modeUse Command Line Interface Mapping devices Mapping single vs. multiple target mode Use the ExpressNAV interface Multiple target mode To remove an iSCSITarget Example \bridgefirmware\I1500110.ima Updating firmwareTo use FTP over GbE to flash new firmware into the iPBridge Configuration & Management firmware update Appendix a Safety standards and compliances European Standards Atto iPBridge 1500E FC Rack Enclosures with Power SuppliesPWRA-0000-FRUPower Module for Atto FC Rack System Atto iPBridge 2500C Cables/SCSI Accessories Appendix C Contact Atto Technology, Inc