ATTO Technology 1550D/E, 1500D/E operation manual Scsi configuration commands

2.2.5 SCSI configuration commands

The SCSI ports are configured with default settings but may be customized to your specifications using the CLI commands in this section.

SCSIInitID

Specifies the SCSI initiator ID to be used on the specified SCSI port. All maps coinciding with the user-specified SCSIInitID must be set to offline and will become invalid upon issuing this command. Choices are 0 to 15.

Default: 7

Set syntax: set SCSIInitID [sb [0-15] ]

Requires a SaveConfiguration command

Get syntax: get SCSIInitID

SCSIPortBusSpeed

Controls the transfer rate at which the iPBridge will attempt to negotiate with its SCSI devices. Ultra 2 SCSI valid only if iPBridge has LVD-capable SCSI ports

Default: Ultra3

Set syntax: set SCSIPortBusSpeed [sb [fast ultra ultra2 ultra3]

Requires a SaveConfiguration command

Get syntax: get SCSIPortBusSpeed [PortNum]

SCSIPortList

Returns a list of available SCSI ports and their current status. Valid status values are O.K. and Failed.

Immediate command: SCSIPortList

SCSIPortSelTimeout

Indicates the time, in milliseconds, that the bridge waits for a response from a SCSI device on the selected port after a selection request.

Get syntax: get SCSIPortSelTimeout [sb]

SCSIPortSyncTransfer

Specifies whether synchronous SCSI transfers should be negotiated with devices on the specified SCSI port.

Default: enabled

Set syntax: set SCSIPortSyncTransfer [[sb [enabled disabled] ]

Requires a SaveConfiguration command Get syntax: get SCSIPortSyncTransfer [sb]

SCSIPortTermination

Configures/reports the SCSI internal termination of the SCSI port identified.

Default: enabled

Set syntax: set SCSIPortTermination [sb [enabled disabled]]

Requires a SaveConfiguration command Get syntax: get SCSIPortTermination [sb]

SCSIPortReset

Resets the specified SCSI bus.

Immediate command: SCSIPortReset [sb]

SCSIPortResetOnStartup

Specifies whether the SCSI port should be reset on power- up or not

Default: enabled

Set syntax: set SCSIPortResetOnStartup [sb [enabled disabled] ]

Requires a SaveConfiguration command Get syntax: get SCSIPortResetOnStartup [sb]

SCSIPortWideTransfer

Specifies whether wide SCSI transfers should be negotiated.

Default: enabled

Set syntax: set SCSIPortWideTransfer [sb [enabled disabled] ]

Requires a SaveConfiguration command Get syntax: get SCSIPortWideTransfer [sb]

SCSITargets

Returns a list of SCSI devices operational on the SCSI port.

Immediate command: SCSITargets 0

31

ATTO Technology Inc. iPBridge Installation and Operation Manual