Appendix C Contact Atto Technology, Inc | ATTO Technology 1550D/E

Appendix C Contact ATTO Technology, Inc.

Customer service, sales Get syntax and technical support are available by phone Monday through Friday, Eastern Standard Time 8:00 a.m. to 8:00 p.m., or by fax and web site 24-hours a day.

ATTO Technology, Inc.

155 CrossPoint Parkway

Amherst, New York 14068

(716)691-1999 • voice

(716)691-9353 • fax http://www.attotech.com

ATTO Technology can also be reached via e-mail at the following addresses: Sales Support: sls@attotech.com

Technical Support:techsupp@attotech.com

v

ATTO Technology Inc. iPBridge Installation and Operation Manual

Image 62

ATTO Technology 1550D/E, 1500D/E operation manual Appendix C Contact Atto Technology, Inc

Contents

IPBridgeTM 1500D/E IPBridgeTM 1550D/E Page Page Contents Connecting Scsi devices to the Scsi port Serial port configuration commands Mapping commands Term Definition GlossaryIntelligent Bridging Architecture, the engine Introduction IPBridge 1550 features Setting up the iPBridgeIPBridge1500 features Possible SAN/NAS Configuration Scsi Pin outs of the RJ11 connector, part number CBL-0911-001 Atto iPBridge 1500E Installation instructions Exhibit 1.1-1 iPBridge 1500E board layout Atto iPBridge 1500D Exhibit 1.2-1 iPBridge 1500D back panel Atto iPBridge 1550E Exhibit 1.3-1 iPBridge 1550E board layout Atto iPBridge 1550D Exhibit 1.4-1 iPBridge 1550D back panel To set Scsi port bus speed and transfer rates Connecting Scsi devices to the Scsi portTo connect Scsi devices to the Atto iPBridge Examples CablingCable types To find the iPBridge Configuring the iPBridgeConnecting using the GbE port To optimize ExpressNAV in Internet Explorer Using Atto ExpressNAVConnecting using the serial port Select Internet Options Enter Using TelnetTo connect using Telnet Installation Configuration To change the default administrator password Change default username, passwordScsi configuration Managing the iPBridge OEM configuration services Ethernet port configurationISCSI configuration Mapping Status Serial Port ConfigurationExpressNAV provides web-based interface To open an ExpressNAV session To use the Advanced Configuration Bridge ConfigurationAdvanced CLI Configuration Restart Firmware CLI provides ASCII-based interface Get Set Command Parameter 1 ParameterCommand conventions Configuration & Management CLI CLI commands summary Command Defaults Example OEM configuration file Defaults Limits General use commands From information commands. Choices are enabled or disabled VerboseMode Diagnostic commands SCSIPortList CLI Error MessagesRouteDisplay SCSITargets Maintenance commands Configuration CLI Scsi configuration commands SpeedWrite SerialPortEcho Serial port configuration commandsSerialPortBaudRate Configuration CLI Ethernet commands ReadOnlyPassword ReadOnlyUsername ISCSI commands ISNSServer MultiTargetMode Route Mapping commandsAutoMap Configuration CLI Privileged OEM configuration services ProductID OEM Config file supported commandsModelNumber VendorID Mapping devices Single target modeUse Command Line Interface Node names Mapping single vs. multiple target mode Multiple target mode Use the ExpressNAV interface Example To remove an iSCSITarget \bridgefirmware\I1500110.ima Updating firmwareTo use FTP over GbE to flash new firmware into the iPBridge Configuration & Management firmware update Appendix a Safety standards and compliances European Standards Atto iPBridge 2500C FC Rack Enclosures with Power SuppliesPWRA-0000-FRUPower Module for Atto FC Rack System Atto iPBridge 1500E Accessories Cables/SCSI Appendix C Contact Atto Technology, Inc