Lowrance electronic LMF-200 manual Suzuki Engine Interface Configuration

4.Press MENU to reset the selected fluid level’s configuration and calibration information to the default settings. You will be taken back to the Bus Devices list where the selected fluid level will be displayed as UnCfg FL.

WARNING:

If you reset any individual EP sensor, it will lose all configuration and calibration settings.

Suzuki Engine Interface Configuration

The LMF-200 can support up to three engines with one engine interface for each engine. If you have one configured engine interface, it will be displayed as Eng Int. If you have three configured fuel flows, they will appear as Port Eng, Cen Eng and Stbd Eng. When the interface is unconfigured it will be shown as UnCfg Eng.

Each fuel flow has an internal menu with the following options: Unset Engine, Change Engine. Fuel Warning, Reset and Reset Fuel Calibration and Reset Trim Calibration.

NOTE:

If, after configuring, unconfiguring or reconfiguring an engine interface, it is not shown on the Bus Devices list, you will have to refresh the list. To do this, let the menu time out and press MENU. Select SYSTEM SETUP and press MENU. Highlight B. DEVICES and press MENU. The Engine Interface will be listed with its new configuration setting.

To configure Suzuki Engine Interface:

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.

2.Highlight B. DEVICES and press MENU. The Bus Devices list will appear.

3.Select UNCFG ENG and press MENU. The following message will appear: Hit Menu to Cfg Eng Int. Press MENU.

4.The Suzuki Engine Model menu will appear with the following options: DF40, DF50, DF60, DF70, DF90/115, DF140, DF150, DF175, DF200/225, DF250 and DF300.

5.Select your Suzuki model engine from the list and press MENU. The Select Engine menu will appear with up to three options: Port, Center and Starboard. (If you have a single-engine configuration, you will not be taken to the Select Engine menu. You will be taken back to the main display.)

44