3.Highlight UNCFG TEMP and press MENU. The following message will appear: Hit Menu to Cfg Temp Sns.
4.Press MENU to be taken to the Selecting Temp menu, which will have three options: Inside, Outside and Water.
5.Highlight one of the Temp options and press MENU. The temp sensor has now has been configured. You will automatically be directed to the Bus Devices list.
To unconfigure EP-35 temp sensor:
1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.
2.Highlight B. DEVICES and press MENU, which will open the Bus Devices list.
3.Select a temp sensor from the Bus Devices list and press MENU. The Configuration Options menu will appear with two choices: Unconfig (Unconfigure) and Reconfig (Reconfigure).
4.Select UNCONFIG and press MENU. The following message will appear: Hit Menu to Unset Device Name.
5.Press MENU to unconfigure the sensor and be directed back to the Bus Devices list, where the temp you unconfigured will be listed as Uncfg Temp.
To reconfigure an EP-35 temp sensor:
To reconfigure a sensor, there must be a configuration name available (Water, Outside or Inside. In the following example, there are three configured temps, one each for inside, outside and water temp. If you try to reconfigure a sensor when the desired configuration name (Water, Outside and Inside) is in use, a Name Already Selected message will appear.
If all three temps are configured, which means there is no name configuration available, follow the first set of instructions. If the desired configuration name is available, follow the second set of instructions.
The steps below will show you how to switch the configuration of a water temp to an outside temp.
If all temps configured (Configuration name unavailable):
1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.
2.Highlight B. DEVICES and press MENU, which will open the Bus Devices list.
3.Highlight WTR TEMP on the Bus Devices list and press MENU, which will launch the Configuration Options menu.
34
