4.Highlight UNSET ENGINE and press MENU which will launch the following message: Hit Menu to Unset Dev Name.
5.Press MENU and you will be taken back to the Bus Devices list.
To reconfigure an EP-10 Fuel Flow:
You will use the Change Engine command to reconfigure a Fuel Flow. Change Engine, however, will only appear on your
If all three fuel flows are configured, which means there is no name configuration available, follow the first set of instructions. If the desired configuration name is available, follow the second set of instructions.
Change Engine (Active only with
The steps below show how to switch the configuration name of a fuel flow from the Port engine to the Starboard engine.
If all fuel flows configured (Configuration name unavailable):
1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.
2.Highlight B. DEVICES and press MENU. The Bus Devices list will appear.
3.Select the Port FFlow and press MENU.
4.Highlight UNSET ENGINE and press MENU. The following message will appear: Hit Menu to Unset Dev Name.
5.Press MENU and you will be taken back to the Bus Devices menu, where fuel flow (formerly Port FFlow) now will be displayed as UnCfg FFlow. Remember: If the fuel flow you just unconfigured is not shown on the Bus Devices the list, you will have to refresh the list. Let the Bus Devices list time out then access it again.
6.Highlight STBD FFLOW and press MENU. Select CHANGE ENGINE and press MENU, which will open the Select Engine menu with up to three options: Port, Cen, Stbd.
7.Highlight PORT and and press MENU.
8.You will be taken back to the Bus Devices list, where the fuel flow you selected (formerly Stbd FFlow) will now be shown as Port FFlow. If the newly configured fuel flow is not shown, refresh the Bus Devices list.
9.Now, select UNCFG FFLOW and press MENU. The following message will appear: Hit Menu to Cfg Flow Sns.
10.Press MENU, which will open the Select Engine menu. Highlight
37
