Lowrance electronic LMF-200 manual Fuel Warning

3.Highlight PORT ENG and press MENU. Select CHANGE ENGINE and press MENU, which will open the Select Engine menu with up to three options (Port, Center and Starboard), depending on your engine-tank configuration.

4.Highlight STARBOARD and press MENU.

5.You will be taken back to the Bus Devices list, where the engine interface you selected (formerly Port Eng) will now be displayed as Stbd Eng. If the newly configured interface is not shown, refresh the Bus Devices list.

Fuel Warning:

The Fuel Warning allows you to set a Low Level or High Level alarm for each Suzuki Engine Interface on the network. A pop-up window will appear if fuel rises above or falls below a threshold of your choosing.

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.

2.Highlight B. DEVICES and press MENU. After a few moments, the Bus Devices list will appear.

3.Select an engine interface and press MENU.

4.Highlight FUEL WRNG and press MENU. The Select Level menu will appear with two options: Low Level and High Level.

5.Select LOW LEVEL and press MENU, which will open the Level Percentage window. It will be set to Off by default. To set the Fuel Warning to High Level Repeat steps 1-4, then select HIGH LEVEL from the Select Level menu.

6.Use the UP and DOWN keys to set the desired fuel warning percentage and press MENU. You will be taken back to the Bus Devices list.

NOTE:

To see fuel remaining information from the Suzuki Engine Interface, you must change the Fuel Remaining Source to Eng/FFlow. See page 28.

Reset:

The Reset command in the engine interface menu allows you to reset configuration and calibration settings for a particular interface.

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.

2.Highlight B. DEVICES and press MENU. The Bus Devices list will appear.

47