Honeywell LYNXR-2 Remote Phone Control Commands, To remotely disarm system, User Functions, Enter

USER FUNCTIONS

Remote Phone Control Feature

Enter:

Your user code

(within eight seconds)

Upon entering remote phone control mode the Lynx will announce “System, enter code”.

Remote Phone Control Commands

To remotely disarm system:

Your user code

+ [1]

To remotely arm in AWAY mode:

Your user code

+ [2]

To remotely arm in STAY mode:

Your user code

+ [3]

To remotely arm in AWAY or STAY mode with no delay:	+ [2] or [3] + [0]
	Your user code
To remotely activate X10 devices 01-06: [#] + [4] + (2-digit) device no.
To remotely activate X10 devices 07 & 08:	+ [#] + [4] + (2-digit) device no.
Your user code
To remotely deactivate X10 devices 01-06: [#] + [7] + (2-digit) device no.
To remotely deactivate X10 devices 07 & 08:	+ [#] + [7] + (2-digit) device no.

To remotely Bypass zones:

Your user code

+ [6] + zone no. Your user code

To remotely activate Forced Bypass:

Your user code

+ [6] + [#]

To remotely check system status: [✻]

To end remote phone session: Hang Up or

Your user code

+ [9]

NOTES: (1) Check with your installer to see if the Forced Bypass mode has been enabled.

(2)When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.

– 37 –