SYSTEM OVERVIEW
Features
•Scheduling feature: Allows you to schedule the automatic activation or deactivation of X10 devices or program events (e.g. alarm clock, reminder, and latch key).
•
•Phone Control: Provides a remote interactive phone capability that permits access to the security system from any
•Speaker Phone Operation: The system is capable of operating as a speaker phone allowing hands free telephone conversation.
•Security Codes: The system is capable of supporting an Installer code, Master user code and six additional User codes including Babysitter and Duress codes. Refer to the SECURITY CODES section for detailed information.
LYNXR-2SIA False Alarm Prevention Features
Many false alarms are caused by simple accidents, like forgetting to close a door when you leave. The
•Exit/Entry Delays: Your security system has been programmed with delay times that allow you to exit the premises after arming, and to disarm the system upon entry, before an alarm occurs. If you leave the premises too late when exiting, or disarm too late when arriving home, it will cause a false alarm. If an alarm occurs, you should disarm the system immediately, and wait for your monitoring company to call you.
•Exit Alarms: Leaving the premises and forgetting to close the door is a common cause of false alarms. The security system will sound an alarm, and display EA, indicating, “exit alarm”. The security system provides extra time for you to disarm the system before dialing your monitoring company. Disarming the system immediately may prevent a call to your monitoring company.
•Exit Time
•Auto Stay Feature: If you arm the system in the “AWAY” mode from the control’s keypad or an RF keypad but no one exits, the alarm system will automatically change to the “STAY” mode. This will prevent you from tripping alarms by remaining on premises. Disarm the system and arm away again when you are ready to leave.
•Burglary Abort Window: Your security system has a delay between the time a burglary alarm sounds, and the time the monitoring company is called. This delay gives you time to disarm the security system before the alarm is reported to the monitoring company. This delay is factory preset at 30 seconds, but may be increased or decreased by your installer.
•False Alarms: If a burglary or fire alarm condition occurs and the system has been disarmed, the keypad will display “CA” or cancel. If this was a false alarm, wait for the monitoring company to call you. They will verify your security code or password and prevent them from calling emergency personnel to respond to a false alarm.