USER FUNCTIONS
Scheduling User Interface
Event Identifier Entries
Note: On systems that are is equipped with a Wireless keypad, reminder announcements and the alarm clock will only be broadcast locally by the
Entry | Event | Comment |
0 | Empty | No event scheduled (or schedule is temporarily disabled) |
|
|
|
1 | X10 Device | Turn an X10 device, either on or off at begin/end times. (will |
|
| have a start and end time to program) (time driven) |
|
| NOTE: SH10A siren cannot be used. |
|
|
|
2 | Latch Key Report | Send a special pager report (7110000) indicating system not |
|
| yet disarmed. (will have a start/end time to send the report) |
|
| (window driven), (reports only to pager) |
|
| NOTE: Option *49 must be programmed to be 6 or higher. |
|
| Make sure unit is armed prior to start of window time. |
|
| In addition a secondary phone number must be |
|
| programmed in Option *42. |
|
|
|
3 | Automatic Stay Arming | Will arm the system automatically, and bypass any open |
| OR | zones, at a given time. It will send a report to the pager and |
| Scheduled Stay Arming | central station, indicating system has been auto armed stay, |
| plus all bypass reports. (will have only a start time to send the | |
|
| report) (time driven) |
|
| NOTES: (1) Prior executing auto stay arming or scheduled |
|
| stay arming, force bypass will be executed - if |
|
| option *23 was enabled. |
|
| (2) If pager report is required, Option *49 must be |
|
| programmed to be 6 or higher. |
|
|
|
4 | Reminder Announcements | Will announce the message recorded by your installer. This |
|
| will be repeated every minute until a key is depressed, or a |
|
| button type zone does an arm or disarm. † |
|
| NOTE: Make sure installer programmed the message at the |
|
| time of installation. |
|
|
|
5 | Alarm Clock | Will start a trouble tone (beep) on the speaker, which will |
|
| continue until a key is depressed. † |
|
| Figure 1. |
