Chapter 3 MOTLoad Firmware
Default VME Settings
As shipped from the factory, the MVME6100 has the following VME configuration programmed via Global Environment Variables (GEVs) for the Tsi148 VME controller. The firmware allows certain VME settings to be changed in order for the user to customize the environment. The following is a description of the default VME settings that are changeable by the user. For more information, refer to the MOTLoad User’s Manual and Tundra’s Tsi148 User Manual, listed in Appendix C, Related Documentation.
■MVME6100> vmeCfg –s –m
Displaying the selected Default VME Setting - interpreted as follows:
VME PCI Master Enable [Y/N] = Y
MVME6100>
The PCI Master is enabled.
■MVME6100> vmeCfg –s –r234
Displaying the selected Default VME Setting - interpreted as follows:
VMEbus Master Control Register = 00000003
MVME6100>
The VMEbus Master Control Register is set to the default (RESET) condition.
■MVME6100> vmeCfg –s –r238
Displaying the selected Default VME Setting - interpreted as follows:
VMEbus Control Register = 00000008
MVME6100>
The VMEbus Control Register is set to a Global Timeout of 2048 μseconds.
■MVME6100> vmeCfg –s –r414
Displaying the selected Default VME Setting - interpreted as follows:
CRG Attribute Register = 00000000
CRG Base Address Upper Register = 00000000
CRG Base Address Lower Register = 00000000
MVME6100>
The CRG Attribute Register is set to the default (RESET) condition.
■MVME6100> vmeCfg –s –i0
Displaying the selected Default VME Setting - interpreted as follows:
Inbound Image 0 Attribute Register = 000227AF
Inbound Image 0 Starting Address Upper Register = 00000000
Inbound Image 0 Starting Address Lower Register = 00000000
Inbound Image 0 Ending Address Upper Register = 00000000
Inbound Image 0 Ending Address Lower Register = 1FFF0000
Inbound Image 0 Translation Offset Upper Register = 00000000
Inbound Image 0 Translation Offset Lower Register = 00000000
MVME6100>
MVME6100 Installation and Use (V6100A/IH2) | 23 |
