Chapter 1 Hardware Preparation and Installation
Connection to Peripherals
When the MVME6100 is installed in a chassis, you are ready to connect peripherals and apply power to the board.
Figure 1-1 on page 6 shows the locations of the various connectors while Table 1-5 lists them for you. Refer to Chapter 5, Pin Assignments for the pin assignments of the connectors listed below.
Table 1-5. MVME6100 Connectors
Connector | Function |
J3 | IPMC761/712 connector |
|
|
J4 | PMC expansion connector |
|
|
J9, J93 | Gigabit Ethernet connectors |
|
|
J11, J12, J13, J14 | PCI mezzanine card (PMC) slot 1 connector |
|
|
J19 | COM1 connector |
|
|
J21, J22, J23, J24 | PCI mezzanine card (PMC) slot 2 connector |
|
|
J29 | COM2 planar connector |
|
|
P1, P2 | VME rear panel connectors |
|
|
Completing the Installation
Verify that hardware is installed and the power/peripheral cables connected are appropriate for your system configuration.
Replace the chassis or system cover, reconnect the system to the AC or DC power source, and turn the equipment power on.
MVME6100 Installation and Use (V6100A/IH2) | 11 |
