Poulan 96042012400, 438706 manual Install belt on engine pulley M, in belt keepers G

Page 19

SERVICE AND ADJUSTMENTS

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

A

B

Fig. 22

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

C

D

Fig. 23

•Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

FJ

H

Fig. 24

•Hook end of clutch cable spring (Q) into hole in idler arm (R).

•Push clutch cable housing guide (P) into bracket, slide collar (L) onto guide and secure with retainer spring (K).

•Install belt on engine pulley (M), in belt keepers (G).

M

Fig. 25

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

R

Q

G MF

G

A E

P

B

C

K
L D	Fig. 26

19

Image 19

Contents PB20H42YT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Before Removing Tractor from Skid Tools Required for AssemblyUnassembled Parts To Remove Tractor from CartonCheck for Proper Position of Belts AssemblyCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor To USE Throttle Control See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig Reverse Operation System ROSBefore Starting the Engine Purge Transmission To Start Engine See FigAutomatic Transmission Warm UP Mowing Tips Schedule MaintenanceMaintenance General RecommendationsTractor BatteryBlade Removal See Fig Engine Deck Washout Port See Fig CleaningSpark Plugs IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Remove Wheel for Repairs See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingTroubleshooting Points Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty