Poulan 96042006800, PB195H46YTX, 418771 manual To Replace Mower Drive Belt See Fig, To Check Brake

Page 21

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER DRIVE BELT (See Fig. 26)

MOWER DRIVE BELT REMOVAL

•Park tractor on a level surface. Engage parking brake.

•Lower attachment lift lever to its lowest position.

•Remove any dirt or grass clippings which may have accumulated around mandrels and entire upper deck surface.

•Remove belt from electric clutch pulley (M), both mandrel pulleys (R) and all idler pulleys (S).

MOWER DRIVE BELT INSTALLATION

•Install belt around all mandrel pulleys (R) and around idler pulleys (S) as shown.

•Install belt onto electric clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

• Raise attachment lift lever to highest position.

BELT REMOVAL -

1.Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

2.Remove belt from stationary idler (A) and clutching idler (B).

3.Remove belt from centerspan idler (C).

6.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (D).

4.Remove belt downward from engine pulley (E).

5.Slide belt toward rear of tractor, off the steering plate

(F) and remove from tractor.

BELT INSTALLATION -

1.

Install new belt from tractor rear to front, over the steer-

 

ing plate (F) and above clutch brake pedal shaft (G).

2.

Pull belt toward front of tractor and roll belt onto engine

 

pulley (E).

S

R

R

M

3.

Pull belt toward rear of tractor. Carefully work belt down

 

around transmission cooling fan and onto the input

 

pulley (D). Be sure belt is inside the belt keeper.

4.

Install belt on centerspan idler (C).

5.

Install belt through stationary idler (A) and clutching

 

idler (B).

6.

Make sure belt is in all pulley grooves and inside all

 

belt guides and keepers.

7.

Install mower (See “TO INSTALL MOWER” in this

 

section of manual).

FIG. 26

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO REPLACE MOTION DRIVE BELT (See Fig. 27)

Park the tractor on level surface. Engage parking brake.

 

For assistance, there is a belt installation guide decal on

 

bottom side of left footrest.

21

 

E

F

A

B G C

D

FIG. 27

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model PB195H46YTXSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Unassembled Parts AssemblyTo Remove Tractor from Carton Unpack CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation DHE Know Your TractorHOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To Operate Mower See FigReverse Operation System ROS Before Starting the EngineTo Operate on Hills To Transport See FigsTo Start Engine See Fig ADD GasolinePurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Install Mower See -21 Service and AdjustmentsTo Remove Mower See Fig Lower DashInstall belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Mower Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig Replacing Battery See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Suggested Guide for Sighting Slopes for Safe Operation HOP Outdoor Products Customer Service DeptCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAService Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Autorisé Dept Service Customer Products Outdoor Canada AuGarantie cette de exclus sont normal l’entretien et Initiale d’achat date la de compter à jours 90 dixUNE Pliez EST Ceci Degrés Suivant LESCorrection Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur GAZ DES Commande LA DE Câble LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision MoteurFig la Voir Batterie LA Replacer Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Réglages ET RévisionFreins LES Vérifier Pour 27 .FIG25 .FIG Tondeuse LA Niveau LE Ajuster Pour24 .FIG 23 .FIG20 .FIG 21 .FIG 19 .FIG18 .FIG Coin le Soulevez C Arrières Bielles LES AttachezFig Voir Courroie LA ET Tondeuse LA InstallerTondeuse LA Enlever Pour 17 .FIGFig la Voir Entretien’ALLUMAGE Bougie Moteur DE D’HUILE Filtre’AIR Tamis LE Nettoyer AIR À FiltreSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantUtilisation Tondre DE Conseils12 .FIG Moteur LE Démarrer Pour Transmission LA PurgerQuetimaauto Sion Transmis DE RéchauffementMoteur LE Démarrer DE Avant 11 et 3 .Fig les VoirMAR EN Fonctionnement DE Système Jauge DE Roues LES Régler Pour FiglaVoirTONDEUSELAUTILISERPOUR10 .FIG Système DU CaractéristiquesVitess GAZ DES Commande LA Utiliser PourDE Régulateur LE Utiliser Comment Fig la Voir Mentnetionsta DE Frein LE Engager PourUtilisation ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier MontagePA LA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourToncar DU Tracteur LE Sortir Pour Montées NON PiécesFig la Voir Batterie LA Vérifier Fig la Voir Siège LE AjustezSommaire Client DU ResponsabilitésProduit DE Spécifications Remorquage EntretienEnfants Général EntretienLES Dans Fonctionnement PentesGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement AUX Imprimé

418771, PB195H46YTX, 96042006800 specifications

The Poulan 96042006800, commonly recognized as the PB195H46YTX lawn tractor, is engineered for homeowners who prioritize efficiency and performance in maintaining their yards. This robust machine boasts a powerful 19.5 HP Briggs & Stratton engine, which offers reliable starting and consistent power delivery. With its robust build and advanced features, the PB195H46YTX is perfect for tackling large lawns and uneven terrains with ease.

One of the standout features of the PB195H46YTX is its 46-inch cutting deck, which allows for a wider cutting swath, reducing the time spent mowing. The deck is designed with a durable material and a reinforced edge, ensuring it withstands the rigors of regular usage while providing a clean and precise cut. Additionally, the tractor offers adjustable cutting heights, enabling users to customize the grass length according to their preferences and the seasonal needs of their lawn.

The transmission system of the PB195H46YTX employs an easy-to-use hydrostatic drive, which offers seamless speed control without the need for manual gear shifting. This feature simplifies operation, allowing users to focus more on steering and mowing rather than constantly adjusting speed. The tractor also features a tight turning radius, making it adept at navigating around obstacles like trees and flower beds.

Comfort and convenience are also vital components of the PB195H46YTX’s design. It comes equipped with a plush, high-back seat with adjustable settings, allowing users to find their optimal position during longer mowing sessions. The ergonomically designed steering wheel and controls are positioned for easy access, minimizing strain and fatigue.

Incorporating advanced technologies, this lawn tractor is built with a durable frame and advanced cutting system, ensuring longevity and high performance. The unit is compatible with various accessories, including baggers and mulchers, making it a versatile option for year-round yard maintenance.

Overall, the Poulan 96042006800, PB195H46YTX, and its associated model number 418771 combine power, comfort, and functionality to provide an exceptional mowing experience. Its features make it a smart choice for homeowners committed to achieving a well-kept lawn without sacrificing their time or effort.
Top Page Image Contents