Jensen JMC-326 instruction manual Repeat All, Programmed Play

Page 11

7.Repeat All:

When the REP/PRST Button is pressed twice, the Repeat All Indicator “REP. ALL” (D17) will be shown in the LCD DISPLAY. The whole disc will be played continuously.

8.To cancel the repeat function, press the REP/PRST Button repeatedly until the Repeat Indicator disappears from the LCD DISPLAY.

9.To stop the CD, press the STOP/BAND Button once no matter the CD is in Play or Pause mode. The LCD DISPLAY will show the total number of tracks on the disc again.

10.Press the FUNCTION Button again to enter Disc 2 mode to play.

11.To turn off the unit, press the Button again. LCD backlight goes off.

PROGRAMMED PLAY

Programmed play can only be done under the following conditions:

i.In CD stop mode;

ii.Alarm function “Off” and

iii.Only one player can be programmed at a time.

1. In CD stop mode, briefly press the PROG/SET Button once. The Program No. “Cd:01” will light up and “01” will change to “00” and blink along with the Program Indicator “PROG” (D18) to prompt for input.

Note: The System will enter Alarm Setting mode if the PROG/SET Button is pressed and held for more than one (1) second. If this happens, please press the STOP/BAND Button or the PROG/SET Button once. The LCD Display reverts to CD mode.

2.Press the " or # Button to select your desired musical track.

3.When the desired track appears in LCD, press the PROG/SET Button to store it in memory. The Program No. will change to “02” and revert to “00” and blink together with the Program Indicator “PROG” (D18) to prompt for another input.

4.Repeat the above procedure until all your desired tracks have been programmed. You can program up to 20 tracks in the program memory. If you attempt to program more than 20 tracks, the Program No. will revert back to “Cd:01” and you will begin overwriting the first track programmed.

5.Press the Button once to start the program playback in your programmed sequence.

REPEAT PLAY MODE

6.Repeat 1:

When the REP/PRST Button is pressed once, the Repeat 1 Indicator “REP.1” (D16) will be shown in the LCD DISPLAY. This single track of music will be played repeatedly.

7.Repeat All:

When the REP/PRST Button is pressed twice, the Repeat All Indicator “REP. ALL” (D17) will be shown in the LCD DISPLAY. The whole disc will be played continuously.

8.To cancel the repeat function, press the REP/PRST Button repeatedly until the Repeat Indicator disappears from the LCD DISPLAY.

10

Image 11
Contents Model JMC-326 Safety Instructions Page On Condensation On PlacementOn Protection Against Laser Energy Exposure Main Unit Functions and ControlsLCD Display Remote ControlAC Operation Power SourceActivating the Remote Control Using the Remote Controller CorrectlyListening to the Radio Setting Alarm and Current TimeOperating Instructions Tips for Best Reception To Preset ChannelsTo Receive Preset Stations CD Operation PLAY/PAUSE ModeSkip and Search Mode Repeat Play ModeProgrammed Play Repeat AllWake to CD, Radio or Buzzer Alarm OperationAUX Operation Snooze Operation Sleep Timer OperationAdjusting the Sleep Time Sleep and Wake to ALARM/CD/RADIOCompact Disc Care Care and MaintenanceCleaning the Unit Symptom Possible Cause Solution Troubleshooting GuideCompliance with FCC Regulations Service