Poulan PC14542B To Remove Wheel for Repairs See Fig, To Start Engine with a Weak Battery See Fig

Page 22

SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL FOR REPAIRS (See Fig. 25)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

 

WHEEL ONLY)

 

FIG. 25

TO START ENGINE WITH A WEAK BATTERY (See Fig. 26)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Customer Responsibili- ties section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

• BLACK cable first from chassis and then from the fully charged battery.

• RED cable last from both batteries.

22

POSITIVE TERMINAL

 

NEGATIVE TERMINAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CHASSIS

 

 

CABLES

POSITIVE

NEGATIVE

TERMINAL

TERMINAL

CHARGED

 

BATTERY

FIG. 26

REPLACING BATTERY (See Figs. 27 and 28)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

•Close battery box door.

SEAT PAN

BATTERY

BOX DOOR

FIG. 27

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model NO. PC14542B General Operation IV. ServiceSafe Operation Practices for Ride-On Mowers II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesKeys Unassembled PartsSteering Wheel Seat Slope SheetTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig HOW to SET UP Your TractorInstall Seat See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Transport Before Starting the EngineTo Operate on Hills Towing Carts and Other ATTACH- MentsADD Gasoline Mowing TipsTo Start Engine See Fig General Recommendations Customer ResponsibilitiesBefore Each USE Tires TractorBrake Operation Operator Presence SystemBelts BatteryEngine Transaxle CoolingTo Service Cartridge Clean AIR ScreenTo Service PRE-CLEANER Engine Cooling Fins See FigSpark Plugs CleaningMuffler IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Installation Belt RemovalTo Adjust Steering Wheel Alignment To Adjust Brake See FigTransaxle Gear Shift Lever Neutral Adjustment See Fig To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Figs To Attach Jumper CablesInterlocks and Relays To Adjust CarburetorTo Replace Headlight Bulb To Replace FuseFuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PC14542BElectrical 2122175566 175158175141 Chassis and Enclosures 176554 17490608162 Drive197 145 120 116 202 150 15173900600 17497372140608 145212Steering Assembly Washer 13/32 x 2-3/8 x 12Ga Engine 170551 148315Seat Assembly 176396 DecalsWheels & Tires 176851Mower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck 171977 17060514174493 174284Service Notes Limited Warranty Limited Warranties ForSighting Guide CUT This OUT Dotted Is a Slope

PC14542B specifications

The Poulan PC14542B is a reliable and efficient lawn mower designed to tackle your yard maintenance needs with ease. This walk-behind mower features a powerful 14.5-horsepower engine that provides ample power to handle various grass types and terrains. Its 42-inch cutting deck allows for quick mowing over large areas, reducing the time spent on lawn care.

One of the key features of the PC14542B is its ease of use. The mower is equipped with a convenient electric start, ensuring that you can get started without the hassle of pulling a cord multiple times. The automatic choke system helps in achieving optimal engine performance, making it user-friendly, especially for those who may not be familiar with traditional mowers.

The cutting height is adjustable, allowing users to customize their mowing experience based on grass type and desired lawn height. With five position choices, you can effortlessly switch between cutting heights ranging from 1.5 to 4 inches. This versatility is essential for maintaining a healthy and aesthetically pleasing lawn throughout the seasons.

In terms of technology, the Poulan PC14542B features a durable steel deck, which improves the mower’s longevity while also ensuring a clean, even cut. The mower is designed to withstand the rigors of regular use, making it a great investment for homeowners. Additionally, the front washout port makes it easy to clean the cutting deck after use, preventing grass buildup and rust.

Another noteworthy characteristic is its maneuverability. The PC14542B is designed with a tight turning radius, allowing users to navigate easily around flower beds, trees, and other obstacles. The smooth-rolling wheels enhance stability and traction, ensuring that you can mow your lawn comfortably and efficiently.

The Poulan PC14542B also offers additional features, such as a rear bagger for collection, a mulch plug for returning nutrients to the soil, and side discharge capabilities for efficient grass dispersal. This flexibility allows homeowners to choose the most suitable mowing option for their lawn care routine.

In summary, the Poulan PC14542B is an excellent choice for those seeking a durable, efficient, and user-friendly lawn mower. Its powerful engine, versatile cutting heights, and easy maintenance options combine to make yard work less daunting and more enjoyable. Whether you’re maintaining a small yard or a larger property, this mower is equipped to meet various mowing needs effectively.
Top Page Image Contents