Poulan PO12538LT warranty Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 12

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F/0°C, USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gaso- hol or using ethanol or methanol) can attract moisture which leads to separation and forma- tion of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place gear shift lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke () position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke () position and retry.

WARM WEATHER STARTING (50° F/10° C and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F/10° C and below)

•When engine starts, allow engine to run with the throttle control in the choke () position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tem- perature.

•The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F/0°C) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjust- ments section of this manual.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents PO12538LT Always Wear EYE Protection During OperationSafety Rules Safe Operation Practices for Ride-On MowersGeneral Service III. ChildrenSafe Handling of Gasoline Table of Contents Battery SteeringKeys Oil Drain Extension Assembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidInstall Seat See Fig Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate on HillsTo Transport Towing Carts and Other AttachmentsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning Engine Cooling System See FigIN-LINE Fuel Filter See Fig Service and Adjustments To Install Mower See FigTo Remove Mower See Fig To Level Mower Housing SIDE-TO-SIDE Adjustment See FigsBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionExcessive Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation
Related manuals
Manual 30 pages 52.05 Kb

PO12538LT specifications

The Poulan PO12538LT is a remarkable lawn tractor designed for homeowners seeking efficiency and reliability in maintaining their lawns. This powerful machine combines robust construction with user-friendly features that make grass cutting a breeze.

At the heart of the Poulan PO12538LT is a robust 12 HP Briggs & Stratton engine. This engine provides ample power for tackling various terrains, whether they are flat or hilly. The engine's design emphasizes longevity and ease of starting, ensuring that users can begin their lawn maintenance tasks without hassle.

One of the standout features of the PO12538LT is its 38-inch cutting deck. This size allows for efficient maneuvering in tight spaces while still providing wide cutting coverage. The cutting deck is equipped with three adjustable blades, which can easily be set to different cutting heights. This feature is essential for achieving the desired grass length, making it ideal for users who prefer a well-manicured lawn.

The tractor utilizes a foot pedal-operated transmission that enables seamless speed adjustments. Operators can effortlessly move forward or reverse without having to disengage from the cutting deck, enhancing the overall mowing experience. This allows for greater control and precision, especially around obstacles like flower beds or trees.

Comfort is a significant focus in the design of the PO12538LT. The seat is designed to provide ample support during extended mowing sessions, reducing fatigue for the operator. Additionally, the tractor incorporates a compact, ergonomic layout that ensures easy access to controls and features, promoting a user-friendly experience.

Another innovative characteristic of the Poulan PO12538LT is its maintenance-friendly design. The easy-clean cutting deck facilitates quick cleaning after mowing, and the accessible engine compartment allows for straightforward maintenance, ensuring the tractor runs efficiently for years.

Moreover, the PO12538LT features an integrated grass catcher option, enabling homeowners to collect clippings for a tidy lawn appearance. This optional accessory can be attached and detached with ease, contributing to the convenience of the tractor.

In summary, the Poulan PO12538LT lawn tractor is an excellent choice for homeowners looking to maintain their yards efficiently. With its powerful engine, adjustable cutting deck, user-friendly controls, and comfort-focused design, it proves to be both reliable and versatile. Whether you have a small suburban yard or a slightly larger plot, the PO12538LT stands ready to tackle your lawn maintenance needs with performance and ease.
Top Page Image Contents