Poulan PBGT26H54 Service and Adjustments, Tractor See Fig, To Remove Mower, To Install Mower

Page 21

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR (See Fig. 27)

TO REMOVE MOWER

•Place attachment clutch in “DISENGAGED” position.

•Lower attachment lift lever to its lowest position.

•Disengage belt tension rod (K) from lock bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and re- lease slowly.

•Remove mower belt from electric clutch pulley (M).

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

•Go to other side of mower and disconnect the suspen- sion arm and rear lift link.

CAUTION: After rear lift links are discon- nected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

•From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the bar falls from the hole in bracket.

•Turn tractor steering wheel to the left as far as it will go.

•Slide mower out from under right side of tractor.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual.

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 28)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

LB

M

K

F

A

E

H

S

C

D

FIG. 27

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model PBGT26H54Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Mower Mower Front Wheel Unassembled PartsSlope Sheet KeysTools Required for Assembly AssemblyTo Remove Tractor from Carton Unpack CartonFirst Install ANTI-SWAY BAR S Install Mower and Drive Belt7/16 Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Ignition Switch Used for starting and stopping the engine Volt Power Port Used for 12-volt accessoriesKnow Your Tractor Stopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To USE Cruise Control -J See FigReverse Operation System ROS Service REMINDER/HOUR MeterTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Install Mower Service and AdjustmentsTractor See Fig To Remove MowerTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt Front Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Weak or dead battery Recharge or replace batteryBrake pedal not depressed Depress brake pedal Corrected, contact an authorized service center Check wiring, switches and connections. If notClean underside of mower housing Clean around mandrels to open vent holesPage L5V 3E4 Limited WarrantyFold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Pliez EST Degrés Suivant LESAutorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Page Connexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage GAZ DES Commande LA DE Câble LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision Carburateur LE Régler PourFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour AvantRoue LA DE PINCEMENT/CARROSSAGE ’ENTRAÎNEMENT Courroie Acer Rempl PourFreins LES Vérifier Pour Deuse30 .FIG 31 .FIGAVANT/ARRIÈRE Ajustement 29 .FIGFig la Voir Tondeuse LA Installer PourTondeuse LA Niveau LE Ajuster Pour Tondeuse LA Enlever PourEntretien Ligne EN Installe Dessence Filtre’ALLUMAGE Bougie Moteur DE D’HUILE Filtre’AIR Tamis LE Nettoyer AIR À FiltreLubrification Sionmistrans LA DE Moteur FluideEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE TableauUtilisation Avant ET Réinstallation LA Après Purgée ÊtreTransmission LA Purger 22 .FIG’ESSENCE Réservoir LE Remplir Moteur LE Démarrer PourMoteur DU D’HUILE Niveau LE Vérifier Quetimaauto’ENTRETIEN/HOROMÈTRE Indicateur Accessoires Autres ET Charrettes DES Remorquer Pour21 et 13 .Fig les Voir Pentes LES Dans Utiliser PourFig la Voir J- Vitess DE Régulateur LE Utiliser Comment Tondeuse LA Utiliser PourJauge DE Roues LES Régler Pour Fig la Voir Mentnetionsta DE Frein LE Engager Pour Reculer Pour ET Avancer PourLétrangleur Utiliser Pour 13 .FIG Froid moteur un démarrer de permet Détrangleur Commande N’EMBRAYAGE Montage 11 .FIG 10 .FIGLA DE Latéraux Suspension DE Bras LES Fixez ROULIS-ANTI Barre LA D’ABORD Installez Courroie LA ET Tondeuse LA InstallerFigs les Voir D’ENTRAÎNEMENT Laté suspension de bras les que vous-Assurez RemarqueLE Pour Exigés Outils LES DU Tracteur LE Sortir PourLA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourClés Pente-Guide Montées NON PiécesRoue Tondeuse Arrières BiellesSommaire U1R DimensionCCA .MIN AMP/HR SL-SG-APITracteurs des sécurité toute Général EntretienEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Pelouse DE Tracteur PBGT26H54 Modèle Lopérateur DE Manuel
Related manuals
Manual 18 pages 36.85 Kb

PBGT26H54 specifications

The Poulan PBGT26H54 is a versatile, robust lawn tractor designed for homeowners seeking a reliable solution for lawn care. This model is particularly appreciated for its blend of power and efficiency, boasting a powerful engine that ensures optimal performance in various mowing conditions.

One of the standout features of the PBGT26H54 is its 26 horsepower Briggs & Stratton engine. This engine is engineered for durability and efficiency, providing enough strength to tackle thick grass and uneven terrain without compromising on performance. The engine is paired with a hydrostatic transmission, which allows for smooth speed adjustments, enabling users to navigate their lawns seamlessly.

The cutting deck on the PBGT26H54 measures 54 inches in width, making it suitable for mowing larger areas in less time. Its design includes a heavy-duty steel structure that ensures durability while maintaining a lightweight feel for ease of maneuverability. The deck also features a cutting height adjustment system, allowing users to select the desired grass length with precision, enhancing the overall lawn appearance.

In terms of technological advancements, the PBGT26H54 is equipped with an integrated mulching capability, which allows grass clippings to be finely shredded and returned to the soil as natural fertilizer. This feature not only promotes a healthier lawn but also reduces the need for bagging and disposal of clippings. Additionally, the tractor’s design includes a side discharge option, providing flexibility based on user preference and lawn needs.

The Poulan PBGT26H54 prioritizes user comfort and convenience. It features an ergonomic seat designed for prolonged use, equipped with armrests to reduce fatigue during extended mowing sessions. The instrument panel is well-organized, allowing for easy gauge visibility and accessible controls, ensuring users can operate the tractor without hassle.

Another essential characteristic of the PBGT26H54 is its durable construction. The robust chassis is built to withstand the rigors of lawn care, providing stability and reliability over time. This model also includes a range of accessories, such as tow-behind carts and implements, which enhance its versatility for various yard tasks beyond just mowing.

In summary, the Poulan PBGT26H54 lawn tractor is a well-rounded machine ideal for homeowners desiring efficiency, comfort, and durability in their lawn maintenance equipment. Its powerful engine, spacious cutting deck, and thoughtful design make it a solid choice for tackling the demands of any lawn care project.
Top Page Image Contents