Poulan PBGT26H54 manual III. Children, IV. Towing, Service

Page 3

SAFETY RULES

Safe Operation Practices for Ride-On Mowers

III. CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the mowing activity. Never assume that children will remain where you last saw them.

Keep children out of the mowing area and in the watchful care of a responsible adult other than the operator.

Be alert and turn machine off if a child enters the area.

Before and while backing, look behind and down for small children.

Never carry children, even with the blades shut off. They may fall off and be seriously injured or interfere with safe machine operation. Children who have been given rides in the past may suddenly appear in the mowing area for another ride and be run over or backed over by the machine.

Never allow children to operate the machine.

Use extra care when approaching blind corners, shrubs, trees, or other objects that may block your view of a child.

IV. TOWING

Tow only with a machine that has a hitch designed for towing. Do not attach towed equipment except at the hitch point.

Follow the manufacturer's recommendation for weight limits for towed equipment and towing on slopes.

Never allow children or others in or on towed equip- ment.

On slopes, the weight of the towed equipment may cause loss of traction and loss of control.

Travel slowly and allow extra distance to stop.

V. SERVICE

SAFE HANDLING OF GASOLINE

To avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.

Extinguish all cigarettes, cigars, pipes, and other sources of ignition.

Use only approved gasoline container.

Never remove gas cap or add fuel with the engine run- ning. Allow engine to cool before refueling.

Never fuel the machine indoors.

Never store the machine or fuel container where there is an open flame, spark, or pilot light such as on a water heater or other appliances.

Never fill containers inside a vehicle or on a truck or trailer bed with plastic liner. Always place containers on the ground away from your vehicle when filling.

Remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such equipment with a portable container, rather than from a gasoline dispenser nozzle.

Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

If fuel is spilled on clothing, change clothing immedi- ately.

Never overfill fuel tank. Replace gas cap and tighten securely.

GENERAL SERVICE

Never operate machine in a closed area.

Keep all nuts and bolts tight to be sure the equipment is in safe working condition.

Never tamper with safety devices. Check their proper operation regularly.

Keep machine free of grass, leaves, or other debris build-up. Clean oil or fuel spillage and remove any fuel- soaked debris. Allow machine to cool before storing.

If you strike a foreign object, stop and inspect the machine. Repair, if necessary, before restarting.

Never make any adjustments or repairs with the engine running.

Check grass catcher components and the discharge guard frequently and replace with manufacturer's rec- ommended parts, when necessary.

Mower blades are sharp. Wrap the blade or wear gloves, and use extra caution when servicing them.

Check brake operation frequently. Adjust and service as required.

Maintain or replace safety and instruction labels, as necessary.

Be sure the area is clear of bystanders before operat- ing. Stop machine if anyone enters the area.

Never carry passengers.

Do not mow in reverse unless absolutely necessary. Always look down and behind before and while back- ing.

Never carry children, even with the blades shut off. They may fall off and be seriously injured or interfere with safe machine operation. Children who have been given rides in the past may suddenly appear in the mowing area for another ride and be run over or backed over by the machine.

Keep children out of the mowing area and in the watchful care of a responsible adult other than the operator.

Be alert and turn machine off if a child enters the area.

Before and while backing, look behind and down for small children.

Mow up and down slopes (15° Max), not across.

Choose a low ground speed so that you will not have to stop or shift while on the slope.

Avoid starting, stopping, or turning on a slope. If the tires lose traction, disengage the blades and proceed slowly straight down the slope.

If machine stops while going uphill, disengage blades, shift into reverse and back down slowly.

Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible.

3

Image 3
Contents Model PBGT26H54II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Keys Unassembled PartsMower Mower Front Wheel Slope SheetUnpack Carton AssemblyTools Required for Assembly To Remove Tractor from CartonFirst Install ANTI-SWAY BAR S Install Mower and Drive Belt7/16 Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Ignition Switch Used for starting and stopping the engine Volt Power Port Used for 12-volt accessoriesKnow Your Tractor Stopping HOW to USE Your TractorTo USE Cruise Control -J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Transport See Figs Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerTo Remove Mower Service and AdjustmentsTo Install Mower Tractor See FigTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Attach Jumper Cables To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Weak or dead battery Recharge or replace batteryBrake pedal not depressed Depress brake pedal Clean around mandrels to open vent holes Check wiring, switches and connections. If notCorrected, contact an authorized service center Clean underside of mower housingPage L5V 3E4 Limited WarrantyFold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Pliez EST Degrés Suivant LESAutorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Page Connexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET RevisionFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour AvantRoue LA DE PINCEMENT/CARROSSAGE Deuse Courroie Acer Rempl Pour’ENTRAÎNEMENT Freins LES Vérifier Pour29 .FIG 31 .FIG30 .FIG AVANT/ARRIÈRE AjustementTondeuse LA Enlever Pour Tondeuse LA Installer PourFig la Voir Tondeuse LA Niveau LE Ajuster PourMoteur DE D’HUILE Filtre Ligne EN Installe Dessence FiltreEntretien ’ALLUMAGE BougieSionmistrans LA DE Moteur Fluide AIR À Filtre’AIR Tamis LE Nettoyer LubrificationEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE Tableau22 .FIG Avant ET Réinstallation LA Après Purgée ÊtreUtilisation Transmission LA PurgerQuetimaauto Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierPentes LES Dans Utiliser Pour Accessoires Autres ET Charrettes DES Remorquer Pour’ENTRETIEN/HOROMÈTRE Indicateur 21 et 13 .Fig les VoirFig la Voir J- Vitess DE Régulateur LE Utiliser Comment Tondeuse LA Utiliser PourJauge DE Roues LES Régler Pour Fig la Voir Mentnetionsta DE Frein LE Engager Pour Reculer Pour ET Avancer PourLétrangleur Utiliser Pour 13 .FIG Froid moteur un démarrer de permet Détrangleur Commande N’EMBRAYAGE Montage 11 .FIG 10 .FIGLA DE Latéraux Suspension DE Bras LES Fixez Laté suspension de bras les que vous-Assurez Remarque Courroie LA ET Tondeuse LA InstallerROULIS-ANTI Barre LA D’ABORD Installez Figs les Voir D’ENTRAÎNEMENTPAL LA DE Tracteur LE Retirer Pour DU Tracteur LE Sortir PourLE Pour Exigés Outils LES LA DE Tracteur LE Retirer PourArrières Bielles Montées NON PiécesClés Pente-Guide Roue TondeuseSL-SG-API U1R DimensionSommaire CCA .MIN AMP/HR’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute En l’utilisation pour ConseilsPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Pelouse DE Tracteur PBGT26H54 Modèle Lopérateur DE Manuel
Related manuals
Manual 18 pages 36.85 Kb

PBGT26H54 specifications

The Poulan PBGT26H54 is a versatile, robust lawn tractor designed for homeowners seeking a reliable solution for lawn care. This model is particularly appreciated for its blend of power and efficiency, boasting a powerful engine that ensures optimal performance in various mowing conditions.

One of the standout features of the PBGT26H54 is its 26 horsepower Briggs & Stratton engine. This engine is engineered for durability and efficiency, providing enough strength to tackle thick grass and uneven terrain without compromising on performance. The engine is paired with a hydrostatic transmission, which allows for smooth speed adjustments, enabling users to navigate their lawns seamlessly.

The cutting deck on the PBGT26H54 measures 54 inches in width, making it suitable for mowing larger areas in less time. Its design includes a heavy-duty steel structure that ensures durability while maintaining a lightweight feel for ease of maneuverability. The deck also features a cutting height adjustment system, allowing users to select the desired grass length with precision, enhancing the overall lawn appearance.

In terms of technological advancements, the PBGT26H54 is equipped with an integrated mulching capability, which allows grass clippings to be finely shredded and returned to the soil as natural fertilizer. This feature not only promotes a healthier lawn but also reduces the need for bagging and disposal of clippings. Additionally, the tractor’s design includes a side discharge option, providing flexibility based on user preference and lawn needs.

The Poulan PBGT26H54 prioritizes user comfort and convenience. It features an ergonomic seat designed for prolonged use, equipped with armrests to reduce fatigue during extended mowing sessions. The instrument panel is well-organized, allowing for easy gauge visibility and accessible controls, ensuring users can operate the tractor without hassle.

Another essential characteristic of the PBGT26H54 is its durable construction. The robust chassis is built to withstand the rigors of lawn care, providing stability and reliability over time. This model also includes a range of accessories, such as tow-behind carts and implements, which enhance its versatility for various yard tasks beyond just mowing.

In summary, the Poulan PBGT26H54 lawn tractor is a well-rounded machine ideal for homeowners desiring efficiency, comfort, and durability in their lawn maintenance equipment. Its powerful engine, spacious cutting deck, and thoughtful design make it a solid choice for tackling the demands of any lawn care project.