Poulan PO18H42STA Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 17)

Mower will be easier to remove from the right side of trac- tor.

•Place attachment clutch in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off engine pulley.

•Remove small retainer spring, and remove clutch spring off pulley bolt.

•Remove large retainer spring, slide collar off and push housing guide out of bracket.

•Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONTLINKSANDHOOKTHECLUTCHSPRINGINTOSQUARE HOLE IN FRAME.

TO INSTALL MOWER (See Fig. 17)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with deflector shield to right side of tractor.

•Lower lift lever to its lowest position.

•Connect front links to mower deck and secure with retainer springs..

•Connect suspension arms to rear deck brackets and secure with retainer springs.

•Connect anti-swaybar to chassis bracket and secure with retainer spring.

•Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

•Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.

•Install belt onto engine pulley.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

 

SMALL RETAINER SPRING

 

 

 

CLUTCH SPRING

 

 

 

 

FLAT WASHER

 

 

SQUARE HOLE

SMALL RETAINER SPRING

 

SUSPENSION

ENGINE PULLEY

 

 

 

ARMS

 

 

 

 

CLUTCH SPRING

 

 

 

 

 

 

 

 

FRONT LINK

RETAINER SPRING

 

 

 

 

ANTI-SWAY BAR

 

 

 

 

 

 

 

 

RETAINER SPRINGS

COLLAR

 

 

 

(BOTH SIDES)

HOUSING GUIDE

LARGE RETAINER

 

 

 

SPRING

BRACKET

 

DEFLECTOR SHIELD

 

 

 

 

 

 

 

FIG. 17

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Model NO. PO18H42STA II. Slope Operation IV. ServiceSafe Operation Practices for Ride-On Mowers General OperationSafety Rules Table of Contents Slope Sheet Unassembled PartsSteering Wheel Seat KeyTo Remove Tractor from Carton AssemblyTools Required for Assembly HOW to SET UP Your TractorCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Operate Mower See FigTo Transport See Figs To Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsGeneral Recommendations MaintenanceLubrication Chart Service DatesTractor Engine Spark Plugs CleaningEngine OIL Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Check Brake Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Replacing Battery See FigsTo Replace Fuse To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysEngine OIL StorageOther Fuel SystemTroubleshooting Points OFF Tractor - Model Number PO18H42STA, Product no 56 SchematicTractor - Model Number PO18H42STA, Product no 56 Electrical KEY Part NO. NO. Description Chassis-pl.ltstlt50 KEY Part Description Tractor - Model Number PO18H42STA, Product no 56 Drive Repair Parts 6867 8546 856 KEY Part NO. NO. Description Tractor - Model Number PO18H42STA, Product no 56 Engine Repair Parts KEY Part Description Wheels & Tires Tractor - Model Number PO18H42STA, Product no 56 DecalsTractor - Model Number PO18H42STA, Product no 56 Mower Lift Repair Parts Tractor - Model Number PO18H42STA, Product no 56 Mower Deck 165892 Service Notes Service Notes Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation

PO18H42STA specifications

The Poulan PO18H42STA is a powerful and versatile lawn tractor designed to make mowing large lawns a breeze. With its robust engine and innovative features, this machine stands out as an exceptional choice for homeowners looking for efficiency and reliability in lawn care.

At the heart of the Poulan PO18H42STA is its 18.5 HP Briggs & Stratton engine, which provides ample power to tackle tough mowing tasks with ease. The engine is known for its durability and performance, ensuring that users can rely on it season after season. Whether you're dealing with thick grass or uneven terrain, the engine's strong output makes it well-suited for a variety of lawn conditions.

A key feature of the PO18H42STA is its 42-inch cutting deck. This deck strikes the perfect balance between maneuverability and cutting width, allowing users to navigate through tight spaces while still covering large areas efficiently. The cutting height can be easily adjusted using a manual lever, offering six different settings for a customized mowing experience tailored to the specific needs of your lawn.

The Poulan PO18H42STA also incorporates a hydrostatic transmission, which provides smooth, precise control over speed and direction. This technology eliminates the need for gear shifting, allowing for seamless operation as you move forward or reverse. It enhances the overall user experience, making it suitable for both seasoned operators and those new to lawn tractors.

For added comfort, this model features a comfortable high-back seat designed to reduce fatigue during longer mowing sessions. The seat is adjustable, allowing users to find their optimal driving position. Additionally, the tractor is equipped with ergonomic controls, making it user-friendly and easy to operate.

In terms of maintenance, the PO18H42STA is designed with accessibility in mind. The engine compartment opens easily for routine checks, and the cutting deck can be removed without hassle for cleaning or blade maintenance. This attention to design simplifies upkeep, ensuring that your lawn tractor remains in top condition.

Overall, the Poulan PO18H42STA is a reliable lawn tractor that combines power, convenience, and comfort. With its strong engine, versatile cutting deck, and user-friendly features, it is an excellent investment for anyone looking to maintain a beautiful lawn with minimal effort. Whether you're mowing grassy expanses or navigating around flower beds, this lawn tractor delivers outstanding performance and versatility.
Top Page Image Contents