Poulan PO17H42STB manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

 

FIG. 27

TERMINAL

KEPS NUT

HEX

COVER

 

BOLT

POSITIVE (RED) CABLE

NEGATIVE (BLACK) CABLE

FIG. 28

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 29)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

01536

FIG. 29

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 30)

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move throttle control lever from slow to choke position. Slowly move lever from choke to fast position.

•Check that holes “A” in governor control lever and hole in governor plate line-up. If holes “A” are not aligned, loosen clamp screw and move throttle cable until holes are aligned. Tighten clamp screw securely.

GOVERNOR CONTROL LEVER

 

 

 

GOVERNOR CONTROL PLATE

HOLES “A”

CLAMP

THROTTLE

 

SCREW

CABLE

 

 

FIG. 30

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, see engine manual.

High speed stop is factory adjusted. Do not adjust - dam- age may result.

IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Model NO. PO17H42STB Safety Rules Safety Rules Table of Contents Slope Sheet Unassembled PartsSteering Wheel Seat KeyBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig HOW to SET UP Your TractorInstall Seat See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTo Operate Mower See Fig To Transport See FigsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Before Each USE MaintenanceLubrication Chart General RecommendationsTractor Engine Spark Plugs CleaningMuffler To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment To Replace Fuse To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsOFF Tractor - Model Number PO17H42STB SchematicTractor - Model Number PO17H42STB Electrical KEY Part NO. NO. Description Tractor - Model Number PO17H42STB Chassis and Enclosures KEY Part Description Tractor - Model Number PO17H42STB Drive 17000612 Tractor - Model Number PO17H42STB Steering Assembly 17490608 Optional Equipment Tractor - Model Number PO17H42STB EngineTractor - Model Number PO17H42STB Mower Lift Tractor - Model Number PO17H42STB Seat Assembly Wheels & Tires Tractor - Model Number PO17H42STB DecalsTractor - Model Number PO17H42STB Mower Deck 165892 Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationPoulan

PO17H42STB specifications

The Poulan PO17H42STB is a reliable and powerful lawn tractor that caters to the needs of homeowners seeking efficiency and performance in their lawn care tasks. With its robust design and user-friendly features, the PO17H42STB is an excellent choice for maintaining medium to large-sized lawns.

One of the standout features of this lawn tractor is its 17.5 horsepower Briggs & Stratton engine. This powerful engine provides ample power to tackle various lawn conditions and enables smooth operation across different terrains. With a hydrostatic transmission, the PO17H42STB offers seamless control over speed and direction, allowing users to navigate their lawn with ease, without the need for manual gear shifting.

The cutting deck of the PO17H42STB spans 42 inches, making it ideal for efficiently mowing larger areas. Equipped with a dual-blade system, the cutting performance is optimized to produce a clean and even cut, reducing the need for multiple passes. Additionally, the cutting height is adjustable, providing versatility for different grass lengths and types, ensuring that your lawn maintains a healthy and attractive appearance.

Comfort and convenience are at the forefront of the PO17H42STB's design. It features an ergonomic seat, allowing for extended periods of use without discomfort. The compact size of the tractor also makes it easy to maneuver in tight spaces, ensuring that corners and edges are not neglected. Furthermore, the large, easy-to-access fuel tank and integrated storage compartment enhance the overall user experience.

Another notable characteristic of the Poulan PO17H42STB is its durability. Built with high-quality materials, it is designed to withstand the rigors of regular use while maintaining its performance over time. The tractor also features a lifetime warranty on the frame, providing peace of mind to users regarding their investment.

In summary, the Poulan PO17H42STB lawn tractor stands out with its powerful engine, efficient cutting deck, and user-centric design. With technologies that enhance both performance and comfort, this model is an excellent option for homeowners looking to keep their lawns well-maintained. Its combination of power, durability, and ease of use makes the PO17H42STB a reliable companion for any lawn care enthusiast.
Top Page Image Contents