Poulan PO17H42STB manual HOW to SET UP Your Tractor, Install Seat See Fig, Check Battery See Fig

Page 7

ASSEMBLY

HOW TO SET UP YOUR TRACTOR

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment bolt.

•Remove adjustment bolt, lock washer and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

•Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

•Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

•Pivot seat and pan forward and assemble adjust- ment bolt, lockwasher and flat washer loosely. Do not tighten

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment bolt securely.

SEAT

SEAT PAN

SHOULDER

BOLT

02466

FLAT WASHER

LOCK WASHER

02465

ADJUSTMENT

BOLT

FIG. 2

CHECK BATTERY (See Fig. 3)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place motion control lever in neutral (N) position.

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Start the engine.After engine has started, move throttle control to idle position.

•Release parking brake.

•Slowly move the motion control lever forward and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

•Turn ignition key to "STOP" position.

Continue with the instructions that follow.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Model NO. PO17H42STB Safety Rules Safety Rules Table of Contents Slope Sheet Unassembled PartsSteering Wheel Seat KeyBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTo Operate Mower See Fig To Transport See FigsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Before Each USE MaintenanceLubrication Chart General RecommendationsTractor Engine Muffler CleaningSpark Plugs To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeTo Adjust Steering Wheel Alignment Transmission REMOVAL/REPLACEMENTFront Wheel TOE-IN/CAMBER To Replace Fuse To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsOFF Tractor - Model Number PO17H42STB SchematicTractor - Model Number PO17H42STB Electrical KEY Part NO. NO. Description Tractor - Model Number PO17H42STB Chassis and Enclosures KEY Part Description Tractor - Model Number PO17H42STB Drive 17000612 Tractor - Model Number PO17H42STB Steering Assembly 17490608 Optional Equipment Tractor - Model Number PO17H42STB EngineTractor - Model Number PO17H42STB Mower Lift Tractor - Model Number PO17H42STB Seat Assembly Wheels & Tires Tractor - Model Number PO17H42STB DecalsTractor - Model Number PO17H42STB Mower Deck 165892 Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationPoulan

PO17H42STB specifications

The Poulan PO17H42STB is a reliable and powerful lawn tractor that caters to the needs of homeowners seeking efficiency and performance in their lawn care tasks. With its robust design and user-friendly features, the PO17H42STB is an excellent choice for maintaining medium to large-sized lawns.

One of the standout features of this lawn tractor is its 17.5 horsepower Briggs & Stratton engine. This powerful engine provides ample power to tackle various lawn conditions and enables smooth operation across different terrains. With a hydrostatic transmission, the PO17H42STB offers seamless control over speed and direction, allowing users to navigate their lawn with ease, without the need for manual gear shifting.

The cutting deck of the PO17H42STB spans 42 inches, making it ideal for efficiently mowing larger areas. Equipped with a dual-blade system, the cutting performance is optimized to produce a clean and even cut, reducing the need for multiple passes. Additionally, the cutting height is adjustable, providing versatility for different grass lengths and types, ensuring that your lawn maintains a healthy and attractive appearance.

Comfort and convenience are at the forefront of the PO17H42STB's design. It features an ergonomic seat, allowing for extended periods of use without discomfort. The compact size of the tractor also makes it easy to maneuver in tight spaces, ensuring that corners and edges are not neglected. Furthermore, the large, easy-to-access fuel tank and integrated storage compartment enhance the overall user experience.

Another notable characteristic of the Poulan PO17H42STB is its durability. Built with high-quality materials, it is designed to withstand the rigors of regular use while maintaining its performance over time. The tractor also features a lifetime warranty on the frame, providing peace of mind to users regarding their investment.

In summary, the Poulan PO17H42STB lawn tractor stands out with its powerful engine, efficient cutting deck, and user-centric design. With technologies that enhance both performance and comfort, this model is an excellent option for homeowners looking to keep their lawns well-maintained. Its combination of power, durability, and ease of use makes the PO17H42STB a reliable companion for any lawn care enthusiast.
Top Page Image Contents