Poulan PR17542STA owner manual To Replace Mower Blade Drive Belt See Fig, To Adjust Brake See Fig

Page 20

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 20)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL

•Remove mower from tractor (See “TO REMOVE MOWER” in this section of this manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

BELT INSTALLATION

•Install new belt in reverse order of removal.

•Make sure belt is in all pulley grooves and inside all belt guides.

•Install mower in reverse order of removal instructions.

IDLER

PULLEYS

MANDREL

PULLEYS

FIG. 20

TO ADJUST BRAKE (See Fig. 21)

Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.

If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted.

•Depress clutch/brake pedal and engage parking brake.

•Measure distance between brake operating arm and nut “A” on brake rod.

•If distance is other than 1-1/2", loosen jam nut and turn nut “A” until distance becomes 1-1/2". Retighten jam nut against nut “A”.

•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is necessary. Contact your nearest au- thorized service center/department.

WITH PARKING BRAKE

1-1/2"

"ENGAGED"

NUT "A"

JAM NUT

OPERATING

ARM

TO REPLACE MOTION DRIVE BELT (See Fig. 22)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

•Remove mower (See “TO REMOVE MOWER” in this section of this manual.)

•Remove belt from stationary idler and clutching idler.

•Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keep- ers.

•Pull belt toward front of tractor and remove downwards from around engine pulley.

•Install new belt by reversing above procedure.

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

TRANSAXLE

PULLEY

FIG. 22

TRANSAXLE GEAR SHIFT LEVER NEUTRAL ADJUSTMENT (See Fig. 23)

The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:

•Make sure transaxle is in neutral (N).

NOTE: When the tractor rear wheels move freely, the transaxle is in neutral.

•Loosen adjustment bolt in front of the right rear wheel.

•Position the gear shift lever in the neutral (N) position.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

GEARSHIFT LEVER

NEUTRAL

LOCK GATE

 

 

ADJUSTMENT

 

BOLT

FIG. 21

20

FIG. 23

 

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents PR17542STA Safety Rules IV. ServiceGeneral Operation II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Hardware Steering WheelSeat Keys Slope SheetAssembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig To SET UP Your Mower for Mulching To Convert to Bagging or DischargingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine Mulching Mowing Tips Mowing TipsTo Start Engine See Fig General Recommendations Lubrication Chart Service DatesCustomer Responsibilities Before Each USETractor Engine Cleaning Engine OIL FilterMuffler Spark PlugsTo Remove Mower see FIG Service and AdjustmentsTo Install Mower see FIG To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Adjust Brake See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigReplacing Battery See Figs To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Carburetor To Adjust Throttle Control Cable See FigTo Adjust Choke Control See Fig Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionWhen operator leaves Schematic Tractor - Model Number PR17542STAElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive Repair Parts Steering Assembly 180656 Wheel Steering Seat Assembly Decals Wheels and TiresEngine 170771 Control Th/ch Flag Mower Deck Repair Parts Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Page Limited Warranty Policy Fold Along This Dotted Line Degree Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PR17542STA specifications

The Poulan PR17542STA is a versatile and powerful lawn mower designed for homeowners seeking efficiency and reliability in their lawn care routine. This self-propelled gas lawn mower features a robust 175cc engine, delivering ample power to tackle various grass types and sizes. Its 21-inch cutting deck is perfect for navigating through tight spaces while providing a broad cutting path, making lawn maintenance both quick and efficient.

One of the standout features of the PR17542STA is its self-propulsion system. The adjustable drive speed allows users to set the pace that best suits their comfort level and working conditions, making it ideal for a range of user abilities. The rear-wheel drive provides excellent traction, particularly on uneven terrain or inclined yards.

The mower comes equipped with a three-in-one cutting system, which offers the flexibility of mulching, side discharge, or bagging grass clippings. This adaptability allows users to choose the most suitable method for their lawn’s needs, promoting optimal lawn health and appearance. Additionally, the 18-gallon grass bag minimizes the frequency of emptying, allowing for uninterrupted mowing sessions.

With an emphasis on user comfort and convenience, the PR17542STA features an ergonomic handle that can be easily adjusted to suit the height of the user. The foldable design of the handle allows for compact storage, making it easy to fit in tight spaces or garages.

Durability is a key characteristic of this mower, as it is constructed with high-quality materials designed to withstand regular use. The rugged wheels and deck ensure reliable performance across various ground conditions. Furthermore, Poulan’s commitment to customer satisfaction is evident in the accessible service and support options available for owners of the PR17542STA.

In terms of maintenance, the easy-access oil fill and drain ports simplify routine servicing, promoting a longer lifespan for the mower. The Poulan PR17542STA is not just a tool; it is an essential partner in maintaining a beautiful lawn, marrying performance with user-centric features to meet the demands of modern lawn care. Whether you’re a seasoned gardener or a first-time homeowner, this mower is designed to deliver exceptional results with every mow.
Top Page Image Contents