Poulan POGT20H48STA manual Install Mower and Drive Belt See Figs

ASSEMBLY

RETAINER

PIN SPRING

SHOULDER

BOLT

ADJUSTING

BAR

GAUGE
WHEEL	3/8-16 CENTER
3/8 WASHER
	LOCKNUT

FIG. 4

INSTALL MOWER AND DRIVE BELT (See Figs. 5 and 6)

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage park- ing brake.

•Cut and remove ties securing anti-sway bar and belts. Swing anti-sway bar to left side of mower deck.

•Slide mower under tractor with deflector shield to right side of tractor.

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

•If equipped, turn height adjustment knob counter- clockwise until it stops.

•Lower mower linkage with attachment lift control.

•Install belt into electric clutch pulley groove.

•Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown.

•Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown.

•Position front plate assembly between front mower brackets. Raise deck and plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between the plate and mower brack- ets.

NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower side-to-side to give space between plate and mower brackets.

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

•Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

•If equipped, turn height adjustment knob clockwise to remove slack from mower suspension.

•Raise deck to highest position.

•Adjust gauge wheels before operating mower as shown in the Operation section of this manual.

		ELECTRIC	FRONT SUSPENSION
	FRONT	CLUTCH	BRACKETS
		PULLEY	FRONT PLATE
CHASSIS	MOWER
BRACKET	BRACKET		ASSEMBLY
GAUGE			SINGLE
WHEEL			LOOP RETAINER
			SPRINGS
			DOUBLE LOOP
			RETAINER
			SPRING
			FLANGED PIN
DOUBLE LOOP
RETAINER SPRING
	ANTI-SWAY
	BAR
USE PLIERS FOR
RETAINER SPRINGS	SUSPENSION ARMS
	DOUBLE LOOP RETAINER
	SPRING (OUTWARD
LOOP UP	POINTING DECK PINS)		DEFLECTOR
			SHIELD

FIG. 5

8