Poulan PDGT26H54A owner manual Suggested Guide for Sighting Slopes for Safe Operation

Page 30

SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION

FOLD		ALONG
THIS		ALONG			DOTTED
THIS	IS		A 15		DOTTED		LINE
	IS			DEGREE
				DEGREE
						SLOPE

ONLY RIDE UP AND DOWN HILL,

NOT ACROSS HILL

15 DEGREES MAX.

WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mow slopes greater than 15 degrees. Make turns gradually to prevent tipping or loss of control. Exercise extreme caution when changing direction on slopes.

1.Fold this page along dotted line indicated above.

2.Hold page before you so that its left edge is vertically parallel to a tree trunk or other upright structure.

3.Sight across the fold in the direction of hill slope you want to measure.

4.Compare the angle of the fold with the slope of the hill.

Image 30

Contents PDGT26H54A ModelGeneral Operation IV. ServiceSafe Operation Practices for RIDE-ON Mowers II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck SeeInstall Mower and Drive Belt Sees To Attach Nose Roller See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsCheck Engine OIL Level Before Starting the EngineTowing Carts and Other ATTACH- Ments ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP Maintenance General RecommendationsBefore Each USE Tractor Transaxle Cooling EngineBelts Transaxle Pump FluidCleaning To Level Mower Housing Service and AdjustmentsTo Install Mower To Remove Mower See FigFRONT-TO-BACK Adjustment See Figs Mower Drive Belt Installation To Replace Mower Drive Belt See FigMower Drive Belt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Adjust Attachment Clutch See FigTo Check and Adjust Brake Transmission REMOVAL/REPLACEMENTFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig To Remove Wheel for RepairsTo Adjust Carburetor To Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control Interlocks and RelaysEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionWith attachment clutch Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service For Service or Replacement Parts