Poulan PDGT26H54A owner manual Product Specifications, Customer Responsibilities

Page 4

PRODUCT SPECIFICATIONS

Gasoline Capacity

5.0 Gallons

 

and type:

Unleaded Regular

 

 

Oil Type (API-SG-SL):

SAE 30 (above 32°F)

 

SAE 5W-30 (below 32°F)

Oil Capacity:

W/Filter:

4.0 Pints

 

W/O Filter:

3.75 Pints

Spark Plug:

Champion QC12YC

(Gap: .040")

 

 

 

 

 

Ground Speed (MPH):

Forward:

5.8

 

Reverse:

2.1

 

 

 

Tire Pressure:

Front:

14 PSI

 

Rear:

10 PSI

 

 

Charging System:

16 AMPS @ 3600 RPM

 

 

 

Battery:

AMP/HR:

35

 

MIN. CCA:

280

 

CASE SIZE: U1R

 

 

Blade Bolt Torque:

45-55 FT. LBS.

 

 

 

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily rem- edy, please contact your nearest authorized service center/ department We have competent, well-trained technicians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

•Read and observe the safety rules.

•Follow a regular schedule in maintaining, caring for and using your tractor.

•Follow the instructions under “Maintenance” and “Stor- age” sections of this owner’s manual.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your nearest authorized service centre/department (See REPAIR PARTS section of this manual).

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents PDGT26H54A ModelIV. Service Safe Operation Practices for RIDE-ON MowersGeneral Operation II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck SeeInstall Mower and Drive Belt Sees To Attach Nose Roller See FigCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Towing Carts and Other ATTACH- MentsCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP General Recommendations MaintenanceBefore Each USE Tractor Engine BeltsTransaxle Cooling Transaxle Pump FluidCleaning Service and Adjustments To Install MowerTo Level Mower Housing To Remove Mower See FigFRONT-TO-BACK Adjustment See Figs To Replace Mower Drive Belt See Fig Mower Drive Belt InstallationMower Drive Belt Removal To Adjust Attachment Clutch See Fig To Check and Adjust BrakeTransaxle Motion Control Lever Neutral Adjustment See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight Bulb Interlocks and RelaysOther Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionWith attachment clutch Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service For Service or Replacement Parts
Top Page Image Contents