Poulan PO14542F manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 17 and 18)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

 

BOTTOM EDGE

 

OF MOWER TO

OF MOWER TO

 

 

GROUND

GROUND

 

 

 

A

GROUND LINE

A

FIG. 17

SUSPENSION

ARM

LIFT LINK ADJUSTMENT NUT

FIG. 18

FRONT-TO-BACK ADJUSTMENT (See Figs. 19 and 20)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns. The two front links must remain equal in length.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

“D”“D”

FIG. 19

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT “E”

NUT “F”

FRONT

LINKSTRUNNION

FIG. 20

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model NO. PO14542F Safety Rules IV. ServiceGeneral Operation II. Slope OperationSafety Rules Safe Operation Practices for Ride-On MowersTable of Contents Unassembled Parts Steering Wheel SeatKeys Slope SheetAssembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CAR- TONInstall Seat See Fig Lower seat into operating position and sit on seatCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Operate on HillsTo Transport Towing Carts and Other ATTACH- MentsTo Start Engine See Fig Mowing TipsADD Gasoline Lubrication Chart Service DatesCustomer Responsibilities General RecommendationsTractor Brake OperationTires Operator Presence SystemBattery EngineBelts Transaxle CoolingClean AIR Screen To Service PRE-CLEANERTo Service Cartridge Engine Cooling Fins See FigCleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Adjust Brake See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Adjust Steering Wheel Alignment Replacing Battery See FigsFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Adjust Carburetor To Replace Headlight BulbInterlocks and Relays To Replace FuseStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionWhen operator leaves Schematic Tractor Model Number PO14542F, Product Number 954 56Electrical 4529KEY Part Description Chassis and Enclosures Repair Parts Drive 72110614 Steering Assembly KEY Part NO. NO. Description Engine KEY Part Description Seat Assembly Decals Wheels & TiresMower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck 72110505 Service Notes Limited Warranty C U M SEH Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX

PO14542F specifications

The Poulan PO14542F is a versatile and efficient lawn mower that stands out in the crowded market of residential lawn care equipment. Designed for both ease of use and effective performance, it is an ideal choice for homeowners looking to maintain a well-groomed lawn without the hassle of complicated machinery.

One of the main features of the Poulan PO14542F is its powerful 14.5 horsepower engine, providing ample strength to tackle various types of grass and uneven terrains. The engine is coupled with a 42-inch cutting deck, which allows for a wider cutting path, ensuring that users can cover more ground with fewer passes. This efficiency is particularly valuable for maintaining larger lawns.

The mower is designed with a hydrostatic transmission, offering smooth and effortless adjustments to speed. This technology makes it easier for users to navigate their lawns, enabling them to slow down or speed up as required without the need to switch gears manually. This feature enhances the overall riding experience, allowing for a more relaxed mowing session.

Another notable characteristic of the Poulan PO14542F is its cutting height adjustment feature. The mower provides multiple height settings, allowing users to customize the length of their grass according to their preferences. Whether you want a close trim or a longer cut, the mower caters to various cutting needs with ease.

User comfort is also a priority in the design of the Poulan PO14542F. The machine features an ergonomic seat with a high back, providing substantial support during long mowing sessions. Additionally, it incorporates easy-to-reach controls, making adjustments simple while driving.

In terms of durability, the Poulan PO14542F is built with a robust steel frame and deck, ensuring longevity and resilience against the elements. Its rugged tires provide excellent traction, making it suitable for various terrains, including slopes and uneven ground.

Overall, the Poulan PO14542F is a reliable and efficient lawn mower that combines power, comfort, and convenience. Its prominent features, such as the hydrostatic transmission, adjustable cutting heights, and durable construction, make it a worthy investment for any homeowner looking to enhance their lawn care routine. With this mower, keeping your lawn pristine becomes a straightforward and enjoyable task.
Top Page Image Contents