Poulan PO14542B owner manual To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER

Page 21

SERVICE AND ADJUSTMENTS

TO ADJUST BRAKE (See Fig. 22)

Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.

If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted.

•Depress clutch/brake pedal and engage parking brake.

•Measure distance between brake operating arm and nut “A” on brake rod.

•If distance is other than 1-1/2", loosen jam nut and turn nut “A” until distance becomes 1-1/2". Retighten jam nut against nut “A”.

•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is necessary. Contact your nearest au- thorized service center/department.

WITH PARKING BRAKE "ENGAGED"

1-1/2"

NUT "A"

JAM NUT

OPERATING

ARM

FIG. 22

TO REPLACE MOTION DRIVE BELT (See Fig. 23)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

•Remove mower (See “TO REMOVE MOWER” in this section of this manual.)

•Remove belt from stationary idler and clutching idler.

•Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keep- ers.

•Pull belt toward front of tractor and remove downwards from around engine pulley.

•Install new belt by reversing above procedure.

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

TRANSAXLE

PULLEY

FIG. 23

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe- in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 24)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

 

WHEEL ONLY)

 

FIG. 24

TO START ENGINE WITH A WEAK BATTERY (See Fig. 25)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against

21chassis.

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model NO. PO14542B Safe Operation Practices for Ride-On Mowers Safety RulesTable of Contents Customer Responsibilities Product SpecificationsUnassembled Parts Steering Wheel SeatKeys Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidHOW to SET UP Your Tractor Check Battery See FigInstall Seat See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTo Transport Towing Carts and Other ATTACH- MentsMowing Tips ADD GasolineTo Start Engine See Fig Customer Responsibilities ¿ Lubrication ChartGeneral Recommendations Before Each USEBrake Operation TractorTires Operator Presence SystemEngine BatteryBelts Transaxle CoolingTo Service PRE-CLEANER Clean AIR Screen See FigTo Service Cartridge Engine Cooling Fins See FigMuffler CleaningSpark Plugs IN-LINE Fuel Filter See FigService and Adjustments To Install Mower See FigTo Remove Mower See Fig Belt Installation To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt RemovalFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Remove Hood and Grill Assembly See Fig Replacing Battery SeeTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Carburetor See Fig To Adjust Throttle Control Cable See FigPreliminary Setting Final SettingOther StorageFuel System Engine OILTroubleshooting Points OFF Tractor - Model Number PO14542B Schematic2122 Electrical175158 175566175141 Chassis and Enclosures 155924X012 117 110 111 115 Drive174973 154407 Bellcrank Clutch173898 Steering Assembly KEY Part NO. NO. Description Engine 170551 14831517060620 Seat Assembly Wheels & Tires DecalsMower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck 171977 165898174284 Service Notes Limited Warranty C U M SEH Only Ride UP and Down Hill Suggested Guide for Sighting Slopes for Safe Operation

PO14542B specifications

The Poulan PO14542B is a robust lawn mower designed to provide efficient cutting performance with user-friendly features. Ideal for homeowners with medium to large yards, this mower effectively combines power, durability, and convenience, making it a popular choice in the landscaping segment.

One of the most notable features of the Poulan PO14542B is its powerful engine. Equipped with a reliable 14.5 HP Briggs & Stratton engine, it delivers ample power to tackle even the toughest grass conditions. This engine provides the necessary torque to ensure consistent cutting performance, allowing users to mow through thick grass without bogging down.

A significant aspect of the Poulan PO14542B is its cutting deck, which measures 42 inches wide. This size strikes a perfect balance between maneuverability and mowing capacity, allowing users to cover more ground in less time. The deck features a durable construction that ensures longevity and performance. Additionally, it provides a 6-position manual height adjustment system, enabling users to customize their cutting height for different grass types and seasonal conditions.

The mower also incorporates efficient technologies that enhance the mowing experience. One such technology is the automatic choke, which simplifies starting the engine. This user-friendly feature minimizes the need for manual adjustments, allowing for easier and faster starts, even after long periods of inactivity.

The Poulan PO14542B is designed with comfort in mind. It features a comfortable, ergonomic seat that provides support during extended mowing sessions. The steering system is also intuitive, allowing for smooth navigation around obstacles in the yard.

Safety is a crucial aspect of this mower, incorporating features such as an operator presence control that immediately shuts off the mower if the operator leaves the seat. This design enhances safety, providing peace of mind while operating the mower.

Maintenance is made easier with accessible components and a durable build that is resistant to wear and tear. The mower's compact design also allows for easy storage, making it an excellent choice for homeowners looking for efficiency and reliability in lawn care.

In summary, the Poulan PO14542B is a versatile lawn mower that delivers impressive power, user-centric features, and safety measures, making it a reliable companion for backyard maintenance. Its combination of performance, comfort, and ease of use makes it a valuable investment for any homeowner aiming to achieve a well-groomed lawn.
Top Page Image Contents