Poulan PDGT26H48A To Attach Nose Roller See Fig, Install Mower and Drive Belt See Figs

ASSEMBLY

TO ATTACH NOSE ROLLER (See Fig. 5)

•Assemble brackets "A" and "B" to the inside of mower mounting brackets as shown. Tighten securely.

NOTE: Be sure bracket tabs are positioned in tab holes in mower brackets.

•Position nose roller between brackets and install rod and retainer spring.

LOCK	HEX BOLT
NUT

• Be sure belt tension rod is in disengaged position.

Install belt into electric clutch pulley groove.

• Place the suspension arms on outward pointing deck

pins. Retain with double loop retainer spring with loops

up as shown.

• Install front plate assembly to tractor suspension

brackets and retain with single loop retainer springs

as shown.

• Position front plate assembly between front mower

brackets. Raise deck and plate assembly to align holes

and insert flanged pins. Secure pins with double loop

retainer springs between the plate assembly and mower

TAB

ROD

"B"

BRACKET

brackets.

NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin.If necessary, move

HOLE

"A" BRACKET NOSE ROLLER

RETAINER SPRING

FIG. 5

INSTALL MOWER AND DRIVE BELT (See Figs. 6 and 7)

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage park- ing brake.

•Cut and remove ties securing anti-sway bar and belts. Swing anti-sway bar to left side of mower deck.

•Slide mower under tractor with deflector shield to right side of tractor.

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

•If equipped, turn height adjustment knob counter- clockwise until it stops.

•Lower mower linkage with attachment lift control.

mower side-to-side to give space between plate and mower brackets.

IMPORTANT: Check belt for proper routing in all mower pulley grooves. Engage belt tension rod by pushing rod into locking bracket.

•Engage belt tension rod by pushing rod into locking bracket.

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

•Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

•If equipped, turn height adjustment knob clockwise to remove slack from mower suspension.

•Raise deck to highest position.

•Adjust gauge wheels before operating mower as shown in the Operation section of this manual.

LOCK BRACKET		FRONT SUSPENSION
	ELECTRIC	BRACKETS
BELT TENSION ROD	CLUTCH PULLEY	DOUBLE LOOP
(DISENGAGED POSITION)
	FRONT MOWER	RETAINER SPRING	FRONT PLATE
CHASSIS	BRACKET		ASSEMBLY
BRACKET
		SINGLE LOOP
GAUGE		RETAINER SPRINGS
		FLANGED PIN
WHEEL
DOUBLE LOOP
RETAINER SPRING
USE PLIERS FOR	ANTI-SWAY
RETAINER	BAR
SPRINGS
	SUSPENSION ARMS
	DOUBLE LOOP		DEFLECTOR
	RETAINER SPRING
LOOP UP	(OUTWARD POINTING		SHIELD
	DECK PINS)

FIG. 6

8