Poulan PDGT26H48A owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 26

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 32)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedures.

HOOD

HEADLIGHT

WIRE

CONNECTOR

02141

FIG. 32

26

Image 26
Contents PDGT26H48A General Operation IV. ServiceSafe Operation Practices for RIDE-ON Mowers II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck See FigInstall Mower and Drive Belt See Figs To Attach Nose Roller See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Operation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionBefore Each USE MaintenanceGeneral Recommendations Tractor Engine Muffler CleaningClean AIR INTAKE/COOLING Areas Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Drive Belt To Replace Mower Blade Secondary Drive Belt See FigTo Replace Motion Drive Belt See Fig To Check and Adjust BrakeTo Adjust Attachment Clutch See Fig To Adjust Steering Wheel ALIGN- Ment Transaxle Motion Control Lever Neutral Adjustment See FigTransmission REMOVAL/REPLACEMENT Front Wheel TOE-IN/CAMBERTo Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove CABLES, Reverse OrderInterlocks and Relays To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb To Replace FuseTo Adjust Carburetor To Adjust Throttle Control Cable See FigTo Adjust Choke Control See Fig Engine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionOFF Schematic Tractor Model Number PDGT26H48A, Product Number 954 56Electrical KEY Part Description Chassis and Enclosures 138Repair Parts Ground Drive 153Transaxle Hydro Gear Steering Assembly 180656 Wheel, Steering Engine Spark Arrester KITSeat Assembly Decals Wheels & TiresLift Assembly Mower Deck KEY Part NO. NO. Description Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service