Poulan PD18H42STB Storage, Other, Fuel System, Engine Oil, Cylinders, Tractor, Battery

Page 26
STORAGE

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANTTO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTUREWHICH LEADSTO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Drain the fuel tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVERTRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Image 26
Contents IMPORTANT MANUAL MODELPD18H42STB OWNERS MANUALSAFE OPERATION PRACTICES FOR RIDE-ON MOWERS SAFETY RULESIV. SERVICE I. GENERAL OPERATIONNever carry passengers or children even with the blades off CUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS Seat UNASSEMBLED PARTSSteering Wheel Gauge WheelHOW TO SET UP YOUR TRACTOR ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY INSTALL SEAT See FigFIG. 4A CHECK BATTERY See FigASSEMBLE GAUGE WHEELS TO MOWER DECK See Fig. 4A TO CONVERT TO BAGGING OR DISCHARGING TO SET UP YOUR MOWER FOR MULCHINGTO INSTALL MULCHER PLATE See Fig. 4B CHECK TIRE PRESSUREOPERATION KNOW YOUR TRACTOR HEIGHT ADJUSTMENT KNOB - Used to adjust the mower cutting heightTO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORTO ADJUST MOWER CUTTING HEIGHT See Fig STOPPING See FigTO OPERATE ON HILLS TO ADJUST GAUGE WHEELS See FigTO OPERATE MOWER See Fig TO TRANSPORT See Figs. 5 andCHECK ENGINE OIL LEVEL BEFORE STARTING THE ENGINETOWING CARTS AND OTHER ATTACH- MENTS ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONMULCHING MOWING TIPS MAX 1/3GENERAL RECOMMENDATIONS MAINTENANCELUBRICATION CHART BEFORE EACH USEBRAKE OPERATION BATTERYTRACTOR TIRESENGINE CLEAN AIR SCREENCLEAN AIR INTAKE/COOLING AREAS V-BELTSAIR FILTER See Fig CLEANINGENGINE OIL FILTER MUFFLERTO REMOVE MOWER See Fig SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Fig TO LEVEL MOWER HOUSING BOTH FRONT LINKS MUST BE EQUAL IN LENGTHTO REPLACE MOTION DRIVE BELT See Fig TO CHECK AND ADJUST BRAKE See FigTO REPLACE MOWER BLADE DRIVE BELT See Fig WITH PARKING BRAKE “ENGAGED”TO ADJUST STEERING WHEEL ALIGNMENT TRANSMISSION REMOVAL/REPLACEMENTTRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT See Fig TO START ENGINE WITH A WEAK BATTERY See FigTO REPLACE HEADLIGHT BULB REPLACING BATTERY See Figs. 29 andTO REMOVE HOOD AND GRILL ASSEMBLY See Fig INTERLOCKS AND RELAYSTO ADJUST THROTTLE CONTROL CABLE See Fig TO ADJUST CARBURETOR See FigFUEL SYSTEM STORAGEOTHER ENGINE OILCAUSE TROUBLESHOOTING POINTSPROBLEM CORRECTIONEngine continues to run TRACTOR - - MODEL NUMBER PD18H42STB REPAIR PARTSSCHEMATIC NON-REMOVABLE REMOVABLE CONNECTIONS CONNECTIONSTRACTOR - - MODEL NUMBER PD18H42STB ELECTRICAL KEY PART NO. NO. DESCRIPTION TRACTOR - - MODEL NUMBER PD18H42STB CHASSIS AND ENCLOSURES chassiselite svpro4174619 drive-hydro.stlt34 TRACTOR - - MODEL NUMBER PD18H42STB DRIVE82 165 REPAIR PARTS TRACTOR - - MODEL NUMBER PD18H42STB STEERING ASSEMBLY steeringpl.lt29REPAIR PARTS TRACTOR - - MODEL NUMBER PD18H42STB ENGINE OPTIONAL EQUIPMENT Spark ArresterREPAIR PARTS TRACTOR - - MODEL NUMBER PD18H42STB SEAT ASSEMBLY seatlt.knob1TRACTOR - - MODEL NUMBER PD18H42STB DECALS WHEELS & TIRESTRACTOR - - MODEL NUMBER PD18H42STB MOWER LIFT lift-rh.1pc.stlt12REPAIR PARTS TRACTOR - - MODEL NUMBER PD18H42STB MOWER DECK Mower Deck Assembly LIMITED WARRANTY SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXPARTS AND SERVICE FOR SERVICE OR REPLACEMENT PARTS