Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 9 for battery operating times.
If the screen is blank, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset shows Low battery along with a flashing 
. If you are on a call in low battery mode, the handset beeps every minute.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action | ||||
The screen is blank, | Battery has no or very | Charge without interruption | ||||
or shows Place in | little charge. The handset | until the screen shows | ||||
charger and |
| flashes. | cannot be used. | HANDSET X (at least | ||
|
|
|
|
|
| 30 minutes). |
|
|
|
|
|
|
|
The screen shows | Battery has enough | Charge without interruption | ||||
Low battery and | charge to be used for a | until the screen shows | ||||
|
| flashes. | short time. | HANDSET X (at least | ||
|
|
|
|
|
| 30 minutes). |
The screen shows | Battery is charged. | To keep the battery charged, | ||||
HANDSET X. |
| place it in the telephone base | ||||
|
|
|
|
|
| or charger when not in use. |
After you install your telephone or power returns following a power outage, the handset will prompt you to set the date and time. To skip setting the date and time, press OFF/CANCEL or BACK.
SET DATE
09/30/09
MM/DD/YY
BACK SET
