HOW to USE Your Tractor

The operation of any tractor can result in foreign objects thrown into the

eyes, which can result in severe eye damage. Always wear safety glasses

or eye shields while operating your tractor or performing any adjustments 00155 or repairs. We recommend a wide vision safety mask over spectacles or

standard safety glasses.

TO SET PARKING BRAKE

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without ﬁrst setting the parking brake will shut off the engine.

1.Depress clutch/brake pedal all the way down and hold.

2.Pull parking brake lever up and release pressure from clutch/brake pedal. Pedal should remain in brake position. Make sure parking brake will hold tractor secure.

	Throttle/Choke	Attachment Clutch Lever
	Throttle/Choke	“Engaged” Position
	Control	“Engaged” Position
	Control
		Ignition Key
		“Disengaged”
	Clutch/	Position
	Clutch/	Parking
	Brake	Parking
	Pedal	Brake
	01844	“Engaged”
		Position

“Brake”	“Disengaged”	Gearshift
Position		Lever
	Position

STOPPING

MOWER BLADES -

•To stop mower blades, move at- tachment clutch lever to disengaged position.

GROUND DRIVE -

•To stop ground drive, depress clutch/ brake pedal all the way down.

•Move gearshift lever to neutral (N) position.

ENGINE -

•Move throttle control to slow position. NOTE: Failure to move throttle control to slow position to allow engine to idle before stopping may cause engine to “backﬁre”.

•Turn ignition key to “STOP” position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

•Never use choke to stop engine. IMPORTANT: Leaving the ignition switch in any position other than "STOP" will cause the battery to discharge and go dead.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “browning” of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor completely, as described above, before leaving the operator's position.

TO USE THROTTLE CONTROL

Always operate engine at full throttle.

•Operating engine at less than full throttle reduces the battery charging rate.

•Full throttle offers the best bagging and mower performance.

TO MOVE FORWARD AND

BACKWARD

The direction and speed of movement is controlled by the gearshift lever.

1.Start tractor with clutch/brake pedal depressed and gearshift lever in neu- tral (N) position.

2.Move gearshift lever to desired po- sition.

3.Slowly release clutch/brake pedal to

start movement.

IMPORTANT: Bring tractor to a complete stop before shifting or changing gears. Failure to do so will shorten the useful life of your transaxle.

TO ADJUST MOWER CUTTING HEIGHT

The position of the attachment lift lever determines the cutting height.

•Grasp lift lever.

•Press plunger with thumb and move

lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.